= How do you reset the computer on a Jeep Cherokee Laredo? = Matt all you need to do is unhook to negative post of the batery for a minute, reconnect the battery and computer should be reset. any recurring trouble codes proably still need to be adressed
You need a scan tool or code reader5 to plug into diagnostic port. Most all repair shops should reset it after correcting whatever tripped the code.
The scan tool only removes or reads the CEL (check engine light) codes. If you need to erase the flash memory of your 96's computer after performing performance enhancing work, they you'll need to follow the next steps exactly.
Disconnect the POSITIVE battery Terminal and touch it to ground ( not the battery negative terminal ) for 30 seconds. The engine block or the A/C compressor pump will work as a ground. (This is to discharge the PCM capacitors, which maintain the Adaptive Memory).
Reconnect the Battery Cable
Turn Ignition Switch to the "On" position but DO NOT start the engine
Turn Headlight "On"
Turn Headlights "Off"
Turn Ignition Key "Off"
You may also simply disconnect the battery for at least 30 minutes to achieve the same results.
Your computer is now at factory default settings. Driving it to operating temperature will get it to start learning the parameters of the new parts you installed.
You need a scan tool to proprly reset the computer.
Disconnect the negative battery cable - Wait at least two minutes - Reconnect the negative battery cable. ----
With a scan tool, or unhook the battery. If the cause of the problem is not repaired, the condition will return.
A 1991 Jeep Cherokee computer is what fits a 1991 Jeep Cherokee.
Where is the fuel reset button on a 2000 jeep Cherokee freedom
The 2009 Jeep Grand-Cherokee has a V6 engine.
Jeep does not use inertia/reset switches.
The maximum payload of the 2009 Jeep Grand-Cherokee is 1180 lbs..
A 1987 Jeep Cherokee does not have a reset button. The fuel system is computer controlled.
A 1990 Jeep Cherokee does not have a reset switch. The fuel system is computer controlled. If not functioning properly there could be a fuse or sensor malfunction.
You can unhook the battery for ten minutes.
A 1991 Jeep Cherokee computer is what fits a 1991 Jeep Cherokee.
you usually reset the computer by removing the negative battery terminal for about 5 minutes, then replace it
Where is the fuel reset button on a 2000 jeep Cherokee freedom
There is no reset for the fuel pump on a Jeep.
Jeep does not use inertia./reset switches. The fuel system is computer controlled with relays.
It does not have a reset.It does not have a reset.
The 2009 Jeep Grand-Cherokee has a V6 engine.
The 2009 Jeep Grand-Cherokee has 12 valves.
Jeep does not use inertia/reset switches.