Step 1. remove interior trim, pulling quick fasteners at the left and right side of the plastic holders, gently pull down head liner and interior trim to expose 8 (eight) bolts that are best removed by using 9mm open end wrench. Be careful to catch them when they come loose or they will go to the hinter regions below trim never to be seen again. 2. Use a non-sharp tool to scour around the window to break the seal of the old window. 3. remove old window and salvage the gasket.
4. Purchase the official window sealant, which is expensive but you are doing this work yourself, so it's not that bad. Lay a bead of sealant around the now vacant sheet metal.
5. replace gasket around new window.
6. Insert window and tighten 8 bolts, going from side to side to assure seal. Tighten only tight, don't crank them down too hard.
7. Replace interior trim.
8. Call Chiropactor to get you out of the back of the seats.
How do you install a rear sliding window on a 2000 Ford Ranger?
How to remove 2000 ford ranger rear window. Need to replace would like to replace with a sliding window need instructions how to do it
Yes, you can install window film on sliding glass doors because the sliding doors are still individual and not connected whereas it can disturb the film and come away.
Very carefully.
Recall the steps you took to remove the window and simply reverse the procedure.
HIT IT WITH A MALLEt
THIS IS NOT A EASY JOB . YOU HAVE TO PULL THE DOOR PANEL AND THEN REMOVE THE ENTIRE WINDOW ASSM. WITH THE MOTOR. NOT A JOB FOR THE AVERAGE PERSON. SUGGEST A DEALER OR REPAIR SHOP it is actually really easy remove the screw and pop off the door panel have the window rolled up then have a piece of PVC pipe and or another person hold the window that the motor out and install the new ones make sure the other person holds the window while you test
Remove the inside door panel of your 1997 Mercury Cougar. Remove the wiring harness from the window motor. Remove the window motor linkage. Remove the window motor retaining bolts. Reverse the process to install the new window motor.
You have to remove the door trim on the inside of the door. Also remove the window crank handle if it is manual windows. 1. remove the window regulator by unbolting the regulator from the door shell and sliding the window guide arms out of the window channels. 2. You then remove either side or both sides of the vertical window channel that the window goes up and down on. 3. Finally, most of the time you need to remove the window rubber seal that runs horizontally along the bottom of the window opening to get the glass and the regulator channel that is attached to the glass out of the door.
remove door panel, install new window
Remove the inside door panel. Unhook the wiring harness from the window motor. Remove the retaining screws. Reverse the process to install the new window motor.
an autoglass shop.