It's not too bad, about 2-3 hours.
You'll need to remove the lower part of the dash under the steering . Then the cable connecting to the shifting lever. To be sure you get the right one, look at the new cable to identify the connection type. You can carefully pop this off the connecting stud with a large flat head screw driver. Next you'll need to pop out a metal u shaped bracket that helps in holding the cable to the dash frame. The cable has a grommet with tabs/wings on it that keep it in place - these need to be squeezed to allow the cable to slip back out of the steel frame. Then you'll need to pull the carpet back. Before doing this it is best to remove the 2 bolts that hold the driver side of the bench seat. Pull the carpet back as far as you can exposing the shift cable path going down just under where you sit, actually a little closer to center floor of the vehicle,under the vehicle you'll see a rubber seal around where the cable goes through the floor. Pop this out with a flat head screw driver. Repeat the same process of removing the cable from under the truck as you did in side with the tabbed grommet as well as popping the cable off the lever of the shifter on the transmission case.
Type your answer here... how do you replace the shift cable on a 2000 expedition 5.4 liter
how to change shift cable on 04 trailblazer
Inspect the shift cable that runs under the drivers floor mat. If the cable sheathing cracks moisture gets in and cause problems.
its on a 93 GMC Sierra Pick up it was working fine and then just one day it just quit
Shift cable? or bar.
I had the same problem. Check the shift cable, the plastic sleeve that keeps the cable straight when shifting may be damaged in which case the cable will need to be replaced.
dude, wats up with all these dam car questions?
The 1998 Chevy Silverado pickup truck shift solenoid can be found on the left-hand side of the engine. The shift solenoid will be near the center of the transmission.
Obviously, it wouldn't shift.
You can adjust the shift cable, on your Ford expedition, by turning the adjustment nuts. There is an adjustment not on each end of the cable.
The 1989 Acura Legend transmission shift cable is held in place with swivel nuts. Loosen the swivel nuts on each end of the cable. The transmission shift cable will come out.