0
Not all.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What causes a Kenmore front load washing machine Belt drive to loosens or comes off?
Overloading your Kenmore front load washing machine can cause increased wear on the Belt drive. Over time, the belt may wear out and break.
Where can one find the belt on a washing machine?
In a top loading machine, remove the front panel. It's easier if the machine is tilted back a little. Under the bottom of the machine, there are two belts, the pump belt and the drive belt. The drive belt is the belt located underneath the pump belt. In a front loading machine, the back panel of the machine must be removed. The belt is located right behind the drum.
Servis washing machine drum not turning?
If the drive motor is working the most likely cause is a worn or broken belt.
Why is your washing machine not washing?
Check if your washing machine is overloaded with clothes or not as this can cause several malfunctioning issues. This includes power problems, defects with the user control board or timer, obstructed drain pump, or a broken drive belt. If it is still not working, it is recommended to consult with a professional appliance repair service to identify and solve the issue as soon as possible.
How can you tell if your washing machine belt is busted?
The drum is not moving
Why does your washing machine fill but does not wash?
There could be a problem with the belt drive of your washer. Manually turn the machine to see if it spins easily. If it does not, you might need to check the belt. It could be too tight or too loose. But that depends on your washer. You can refer to http://www.washingmachineadvisor.com if you do not know how to repair your brand of washer.
How do you reset a washing machine?
This is a great video on how to take apart the washing machine. In reverse order, he shows you parts of a washing machine. Check out the instructions here: http://www.mindbites.com/lesson/425-fix-washing-machine
Replace drive belt on washing mach?
That is a cheaper alternative to buying a new washer.
Why wont Kenmore washing machine spin?
The wig-wag or spin actuator or belt is faulty. -Simple problem for someone experienced in washing machines.
What type of motor is used in washing machine?
an electric motor is used in a washing machineIt's a typical electric motor usually with a belt off of it to rotate the drum.
How do you replace a drive belt on a 38yard machine lawn mower?
How do you replace a mower deck belt on a stx38 hydro
How is a washing machine a computer system?
A computer within a washing machine controls many aspects: The user interface, that is, buttons, LEDs, display, buzzer, are all driven and managed by a computer. The washing program is controlled by a computer: when to heat the water and how much, when and how to spin, etc. Modern washing machines measure the cleanness of the washing and optimize the washing cycle's duration to wash as long as necessary while completing as soon as possible. Modern washing machines also feature sophisticated spinning and load-balancing algorithms which reduce vibrations during the spinning, thus reducing noise and mechanical stress. A washing machine's computer will also monitor safety equipment: for example, a frontloader's door must be securely locked before water is allowed in. Water flow must be confirmed, and the required amount of water must be in the machine before the heating is allowed on, etc. The washing machine's computer will also monitor the machine's general state of health and maintenance. For example, after a set number of hours of active usage, the machine might display a recommendation to replace the drive belt, or to clean the fluff filter.
