Sweat a female fitting on the copper or use a compression coupling between the two.
When I have to connect copper to lead "D" I usually solder the copper to the lead or wipe a lead joint depending on the diameter To connect copper to cast iron ,.... If there is a hub I caulk the copper directly into the CI with oakum and poured lead (molten) OR one can solder / braze a female adapter fitting and screw the copper into a CI female fitting
You can often find a modern connector such as Sharkbite or Qwest fitting to do this.
YOU thread or braze copper pipe Copper tubling you solder, braze, flaire, compression ring, mechincal joints
The same that is used above ground. Sweat fitting coupler. I would not use copper underground in an area that has winter.
id means inside diameter, od means outside diameter, copper pipe and tubing is measured by the od, therefore the od the pipe or tubing will be the same as the id of the fitting
It is probably referring to the type of fitting. A fitting that is soldered to a copper pipe. It is called sweating when you use solder and a torch to connect copper pipe together or attach fittings to copper pipe.
In order to connect a chromed steel pipe to a copper pipe, you will need a brass fitting. These two pipes will not fit into each other otherwise.
A threaded copper fitting on the copper side, male or female, and the galvanized is screwed into it.
When I have to connect copper to lead "D" I usually solder the copper to the lead or wipe a lead joint depending on the diameter To connect copper to cast iron ,.... If there is a hub I caulk the copper directly into the CI with oakum and poured lead (molten) OR one can solder / braze a female adapter fitting and screw the copper into a CI female fitting
You can often find a modern connector such as Sharkbite or Qwest fitting to do this.
You use a compression fitting or something like a Sharkbite.
Flare copper pipe and use a flared shutoff valve. If valve isn't flared, use an adapter fitting between copper flared pipe and valve.
Male or female sharkbite adapter on threaded end of galvanized pipe or fitting. No other way.
Water main coming into house usually 3/4" K copper pipe. Depending on local plumbing code, fitting usually is flared or soldered.
You can't. There is no fitting to do this. Galvanized has to be threaded.
Take either an SOS pad or a wire brush and rough up both the inside of the brass fitting and outside of copper pipe, put the copper pipe into the fitting and solder around it.
Yes. Use a threaded fitting, male or female as needed on the copper and screw the galvanized into it.You must use a dielectric fitting to connect copper to galvanized pipe. If you don't, a galvanic reaction will occur and the piping will corrode and leak. You can use a Dielectric Union or a Threaded Brass fitting to join the two types of piping together.UNIONS can leak the best answer would have been a dielectric nipple