0
It could be. The manufacturer decides what is part of there "powertrain warranty".
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Where is the slave cylinder?
It depends on the slave cylinder that you are asking about. The slave cylinder for a hydralic clutch would be neer the bell housing to disengage the clutch. The slave cylinder for drum brakes would be inside the drum between the two shoes, and pressure applied into this cylinder would engage the brakes.AnswerThe clutch slave is inside the bell housing on most of these. You have to pull the transmission etc to change it out. ANSWERSTRANSMISSION HOUSING OUTSIDE FLUID PIPE
Does the slave cylinder open and close?
No, the slave cylinder is a typical hydraulic piston; if the system was 'opened' then the fluid would come out.
Is it the master or slave cylinder that sits outside the transmission casing on a 94 Toyota Tercel?
The slave cylinder would be the part at the transmission.
Why would clutch fluid leak out on a 88 Toyota corolla?
Bad clutch slave cylinder or failed soft hose from master to slave cylinder.
Braks lights Nissan Sentra 2007 20?
If you 07 Nissan sentra and has manual transmission, you have a big link in your Slave cylinder inside of your transmission and it will burn your clutch and Nissan will charge you $1600.00 Dollars to repair even if fall in powertrain warranty. fyi, is a good car but Nissan sucks even I got video and pictures of this mess Bortiz7623@yahoo.com
Does a 1986 ford f150 have a slave cylinder?
if its a standard/manual truck. slave cylinder would be located on the firewall next to the brake booster, and would take standard dot 3 brake fluid.
What would cause clutch fluid to leak from the slave cylinder so when you start the vehicle the clutch stays to the floor and is floppy with no resistance?
The slave cylinder has failed and will need replaced.
94 ford f350 slave cylinder bleeder?
It has to be on the slave cylinder, not sure that was your question.
Where is the Jeep Wrangler slave cylinder?
how to replace the slave cylinder on a 1993 jeep wrangler
How do you put fluid in the slave cylinder on a 2000 Toyota Tacoma?
Remember, keep the master cylinder full so you don't suck air into the slave cylinder. Then you put the fluid in the slave cylinder.
Where is the bleeder on the clutch slave cylinder?
In cylinder
Where is your slave cylinder?
The slave cylinder for a hydraulic clutch is located inside the manual transmission bellhousing
