0
Would it be acceptable to use 5W-30 motor oil in a full size 1999 Isuzu Trooper for oil change?
Wiki User
∙ 15y ago
5w-30 is the best to use on the trooper, i take it, it is the 3.0DT? Its a very fickle engine and doesnt like any other type
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
What is the sister vehicle of a 1999 Isuzu trooper would it be a suzuki?
The sister vehicle of the Isuzu Trooper is the Acura SLX
Are Isuzu trooper reliable?
No they are too small a company. After working at a Gm, Suzuki, Isuzu dealership I would recomend a Suzuki
Why would a 97 Isuzu Trooper shake at 70-75mph but not before or after?
My guess would be wheel balance.
What would be making your 1999 Isuzu trooper run hot?
I would start by checking the thermostat, it may not be opening.
What type of freon do you use for 1991 Isuzu Trooper?
Would have been built for R12, can be converted to R134a.
What would cause antifreeze in the oil on a 194 Isuzu trooper?
Bad gaskets- including a head gasket- would be a likely suspect.
What would cause the tail light fuse to keep blowing on a 1991 Isuzu trooper?
Short in the wiring or one of the bulb receptacles.
Why would an Isuzu trooper stall when driving for about 15 minutes and then restart to drive fine?
If the check engine light is on...might be a dirty EGR valve.
What would make strong gas smell come from 1988 Isuzu Trooper II and make it idle rough?
Carb.? Float sticking and flooding
Where is tcm on 93 Isuzu trooper?
On my 1995 it is under the the dash where the clutch would be located. It is chrome colored and has plugin visible. I am certain the 1992 is identical.
What year of Isuzu Rodeo or trooper engine would fit in a 1989 Isuzu Rodeo?
What motor is my question. it's either the 2.6L 4-Cylinder or the 3.2L V6 and having owned 4 rodeos and 2 Amigos (as well as 1 trooper) I know that the rodeo was first introduced in 1990. again, the 2.6L 4-Cylinder or the 3.2L V6 are the only ones that would fit.
How would you remove the driver side axle on an Isuzu Trooper ls 4x4 3.2 v6 dohc?
As an Isuzu mechanic, I would not recommend an individual trying this. There is a large plate holding it in place, along with two snap rings behind it holding the bearing and seal in place.
