0
Will the IC 74ls08 get damage if we apply 6 volts instead of 5 volts as supply voltage?
Wiki User
∙ 11y ago
The 74LS series is designed for a 5 v supply so they should be used with the right supply voltage. 6 v would probably not destroy them but the logic functions might be impaired.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What is typical single phase voltage in Canada?
The standard nominal voltage in Canada for a single-phase residential supply is 240/120-V split-phase supply.
What is hidden damage when our utility transformer fed 279 and 138 volts in our home for an extended period instead of 240 and 120 volts?
There may be none, depending on what you have in your home that could be damaged. Generally, this will lower current in 3 phase induction type motors. In most everything else, current draw will go up. Many devices can handle 1.15pu voltage levels, though. Note typical power spikes can be 1.2 pu (120% expected). Sensitive electronics such as computers, LCDs, etc. could have power supply problems (assuming you don't have some sort of battery backup system protecting them). If you own a computer with a cheap power supply, I wouldn't be suprised if this shows some damage. Damage to the power supply can result in damage to other components in the computer over time. When you buy a bundled computer, the manufacturer often cuts cost as much as possible on the power supply - this is why I recommend buying your own, and buying a good one (if you have the knowhow...). Some LCDs are designed with very low voltage margins - I've seen one where the main power supply capacitors were barely sized to expected voltage input, so the first power surge took them out. Note this would have happened in your case, and would have happened almost immediately. Generally, I would say equipment that uses a small transformer, and has voltage regulation on the DC side (most electronics) will be fine (no percievable damage in the long run) if you haven't noticed problems already.
What is my 240 v supply at home ac or dc?
The household supply in the UK is 240 V and is AC (alternate current).
What voltage mercury lamp works?
the supply voltage to a mercury vapour lamp (from the electromagnetic ballast) is 130vac
Does opening a switch break an electric device?
No, it opens the supply voltage and hence the supply current to the load.
What is the maximum supply voltage for a 74LS08?
The maximum supply voltage per the data sheet is 5.25 volts. This is a common max for TTL type IC's.
Can i use 14 voltage batterie on my laptop instead of 11.1 voltage?
In general, No. You should use the battery voltage that is designed for the laptop. Using a different voltage will result in a degradation of performance, and it could damage the power supply circuitry in the laptop. If, however, the manufacturer certifies 14V batteries in your 11.1V laptop, then go ahead, but do so only if certified, otherwise you risk damaging your laptop out of warranty.
How can you get 12volts supply from speaker?
You can not. Speakers do not supply a voltage they need a voltage to operate correctly.
What are the application of core type transformer?
The main application for a core type transformer is to increase voltage from a standard 240v supply up to 415v instead of using a 3 phase supply.
The voltage across a short circuit is equal to?
zero? the supply voltage? the supply voltage minus the individual coltage drops? the sum of the individual voltage drops? which one?
Do you add electrical supply voltage and induced voltage of a coil to get total voltage on the coil?
The induced voltage acts to oppose any change in current that is causing it. So, if the current is increasing, then the induced voltage will act in the opposite direction to the supply voltage; if the current is decreasing, then the induced voltage will act in the same direction as the supply voltage.
How many watts will be neede to supply 400 amp welder?
It depends on the supply voltage watts = current in amps times the supply voltage
What is the Difference between supply voltage and input voltage?
no difference...
Why is 110v televisoin set damage when plugged into a 220v source?
Because it is designed for 120 volts. Internal voltages and current derived from the supply voltage are out of specification and will likely cause failed components that are not compatible with the higher voltage.
What is impresses voltage?
It is another way of saying "Apply a voltage" or "supply (something) with a voltage"
Can you use a 12VCD 500mA instead of a7.5V 800mA AC power adapter?
Yes you can. But it may damage your computers power supply.
What are the features of power supply?
what the characteristic of power supply? Ans: The electronic part of the Audine camera requires a +/-15V symmetrical power supply. Consumption is 30 mA for the positive voltage and 10 mA for the negative voltage. If possible, the peak-to-peak ripple must be lower than 5 mV. To reduce the electronic noise level, it is recommended to choose a linear type power supply instead of a switching power supply since the aim is to control sensitive electronic circuits such as the ones in a CCD camera. The required power supply can be easily built using 7815-type voltage regulators (for the positive voltage) and 7915 regulators for the negative voltage as well as a transformer, a few capacitors and rectifier diodes.
