Yes, it will fit and mount up just fine. But you will have to make sure the front differential gear ratio matches that of your rear differential. Or what you could do is swap the transmission from the Forester along with the rear differential from the Forester
Yes
How do I get to the flywheel bolts on a 98 dodge dakota to remove a transmission
yes the bolt pattern is the same
The starter is located on the right hand side of the engine near the bottom. You can follow the positive battery cable from the battery to the starter.
On a 98 eclipse rs Manual, the filter is located inside the transmission. It is behind the square inspection plate just behind the driver side wheel. It have a few bolts holding it on..and it doesn't have a drain plug..Hope this helps
The towing capacity is 2000lbs with trailer brakes, and 1000lbs without. This info pertains to a Class I hitch assembly with a 1.25" ball on a Subaru Forester 98-01. If towing with an automatic transmission, first install a transmission cooler. **2001 Subaru Forester L Owners Manual.
IACV
They are different gear ratios. Outback turns 3100 @ 65 while the Forester turns about 2700. I'm currently running this combo and have about 4-5k on it expecting viscous coupling to go when I need it the least, then I go nowhere and I'm on as unmaintained road in the Colorado Rocky's so I'm looking for the correct answer as well.
Mounted on top and inside the fuel tank.
It is a staked joint drive shaft. It is not meant to be serviced.
Where is the sensor of the transmission control located Answering the first question since the second makes no sense. The car's Electronic Control Module is located under the carpeting on the front seat passenger's floor.
can i yous transmission Ford focus
it was most likely installed incorrectly or you had a pulley seize up
Will a tranny from a 2001 corolla fit a 98 corolla
Sorry to hear that. I like mine. Perhaps you should try a new one?
yes, I just put a 1997 2.5 liter engine in a 1998
In the front of the engine where the pulleys and belts are located. It's behind the pulleys under the black plastic cover.