answersLogoWhite

0


Best Answer
Answer

the brake light switch down at the brake pedal is most likely bad .

Answer

First, use a test light to check to see if the bulbs are getting power. If not, check the stop light switch. This is the switch connected to the brake pedal. When the brake pedal is pushed, this switch closes the circut and causes the brake lights to come on.

Answer

The brake lights are wired through the hazard switch, Turn the hazard lights on and off several times, the brake lights should start working.

the hazzard swith has a little plastic piece that dry rots over time, go to junkyard and by the switch, very simole job, cost me 25 cents

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why would the brake lights stop working on a 1994 Buick Skylark if the fuses and bulbs are okay?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

95 Buick Skylark back brake drums?

Yes.


Where is the fuse located for the interior lights on a 1993 Buick Skylark?

It's under a panel door that says FUSES on it that's under the dash over the brake pedal.


Where is the connector for the brake light switch in a 1991 Buick Skylark 3 3L?

I've got a '92 skylark, and had a problem with the brake lights staying on even after the car was off. There is an adjustment that is connected to the brake pedal that you can adjust the tension on. It's kind of a pain to get up under there unless you're skinny though.


Why would '97 Buick Skylark brake lights turn signals hazards all stop working at once while center brake light in rear window works fuses are good changed turn signal switch and still doesn't work?

The only thing common to all those lights (but not to the center brake light) is the hazard switch. I'd check that next. On my 96 Century the hazards override the signals and brake lights meaning that the signals and brake lights must be wired into the hazard switch somehow.


How do you replace the power brake booster on a 97 buick skylark?

who knows i have the same question


Why do your turn signals work but you have no brake lights on a 94 Buick Roadmaster sedan?

Sounds like it's not your bulb that is bad. It may be your brake switch isn't working.


Where is the brake light switch on 2004 Buick Rendezvous?

I have 05 with no brake lights


Where is the daytime running lights module located 1997 Buick skylark?

On my 1999 Buick Regal the DRL module is located on the outside foot well behind the parking brake pedal under the carpet. My DRL has gone bad and is making the car quit.


No brake lights on s-10 blazer?

It is important to have working brake lights on a vehicle. If the brake lights are not working a person should first check the fuse, bulbs and at last the wiring.


How do you replace signal bulb and brake bulb on a 94 Buick Skylark?

Just turn the housing the bulb is in and pull it out. Remove and replace the bulb the same way. For the rear lights, you have to push on a tab to release the housing the bulbs are in.


Why would my 1995 buick skylark lose brake lights or turn signals?

Check the bulbs - they are double filamented - smaller for stop/turn and larrger for tailights Check the sockets for corrosion Check the sockets for power /ground


What causes a brake light on the dashboard to come on and go off at random in a 1997 Buick Skylark?

I'd check the sensor for the emergency brake. It's probably faulty.