ive been a plumber 16 years , so to make it simple, 1st if its new construction, it is because the plumber didnt wipe the flux off of the pipes, and so forth causes a green film in what is called OXIDATION, this can be detremental to your pipes , big time. so wipr the pipes with warm water and a mild soap. 2nd scenario , it to where the pipes have made contact with another metal i.e. a screw or a nail. So in a way to say without having a service plumber come tell ya ya it will be 1000 ish bucks , and ya think !#$&#&$! get a flash light serarch near the areas before and after ya seen the green , look for a forieghn metal touching it some where, move it away use black electrical tape to keep it the heck from making contact INOTHERWORDS insulate it from the steel, aluminum , iron especially. then wipe with a abraisive dish sponge , with warm water and soap, or steel wool, then wipe to a dry. in a nut shell you can do it solo , and save big $$$ .Jason Romero(=. times are tough at the moment. in a nut shell you just saved $'s by wiki..... brass is the only safe metal to make contact with copper
If it is actually growing out of your faucet, you may have algae growing in your water supply. In most areas you may take a water sample to the local health department, or other similar place for testing.
rust colored water? This frequently happens when the water department is flushing lines upstream of you, or if there has been a large fire in neighborhood you may also have this to a smaller extent. Moving large amount of water breaks free rust in the pipes. It will generally go away within a few hours, you may have to run your lines a little bit.
If you have an older home it sounds like you could have copper piping. It's best to get a plumber up to see what's causing this. Meanwhile, drink bottled water until you find out.
Copper is used as hot water pipes because the copper will not corrode when the hot water goes through the pipes
Copper is used as hot water pipes because the copper will not corrode when the hot water goes through the pipes
No this is not necessary. Install the pipes as per usual. You can insulate the hot water pipes up to two meters or up to two yards from the hot water outlet from the hot water tank to prevent this. No this is not necessary. Install the pipes as per usual. You can insulate the hot water pipes up to two meters or up to two yards from the hot water outlet from the hot water tank to prevent this.
Heat tape is just for keeping the pipes from freezing, it does not heat the water. That's what the hot water heater is for.
Your hot water pipes have rust in them.
Well if water is too cold, pipes will contract and if water is too hot, the pipes will expand.
yes
You know it by touching and feeling the pipes on the hot water side; if they are hot, there is water running through the pipes and obviously the heater valve is open on hot side.
The water pipes are full of cold water. All that cold water has to be flushed from the pipes before the hot water from the tank reaches your faucet.
Yes
Water pipes may be covered with foam rubber to stop condensation dripping from the surface of cold water pipes in warm and damp climates, and to insulate hot water pipes so the water in them does not cool while flowing from the hot water tank to the faucet,
There are pipes that feed from radiator to radiator. Or there can be multiple feed pipes and return pipes, it varies based on installation.