It causes the disruption of the fuse, switching off the disjunctor, or set on fire the conductors if there isn'ta circuit protector and therefore burns the parts of the electric device. The cause of too much current in a ciucuit is always a resistance that has a low value. To check the cause of the excess of current in a circuit is necessary to measure all the components.
When too much current passes through a conductor it can cause an overload of electricity which if not earthed can be very dangerous to human contact. If the object that is conducting the electricity is touched than this can cause an electrocution, which is when too much current passes through a person's body to try and reach the ground to earth itself. When more amperage than an electrical wire can handle in a circuit is produced than the wires start to burn and can cause a fire (Thiele, Unknown). Today most appliances have a safety device attached to the appliance to stop damage from happening.
High current results in excessive heat in wiring.
(Lol dude, CHEATING IS BAD.) *Even though I do it* xD
Current can cause heating; too much current, and a circuit will burn out.
A fuse.
Too much current for the rating of the bulb.
Circuit Breakers and Fuses limit the amount of current flowing through the circuit.
A fuse protects the (expensive) circuit for too high currents. When the current becomes too high the (cheap) fuse melts and the current is stopped, preferably before damage has been done to the circuit.
I assume you mean - 'Why does a circuit fail to work if the operating voltage is too high or too low?' A certain specific voltage is needed to overcome the natural resistance in circuit components. For instance in simple transistors, this is 0.7V to get the transistor to switch on and 1.4V is lost across the switched junction. This is why may circuits operate at above 3V. The rest of the circuit is designed to operate at the specified voltage and if you go too high, too much current will flow through the circuit and it will fail in the same way a fuse will blow if too much current is passed through it.
A circuit breaker is a device used to open a circuit if too much current flows through it.
A circuit breaker or a fuse is used to insure that too much current does not flow through one circuit.
Circuit Breaker.
Either a short to ground, or too much current draw in that circuit.Either a short to ground, or too much current draw in that circuit.
This would not be a hypothesis, but an explanation. A fuse is a piece of wire with a low melting point which melts if too much current flows in the circuit. It is designed to break before the rest of the circuit is damaged.
A fuse.
A fuse.
Circuit breakers are in place to prevent an over-current condition. When too much current is passed through a wire, it overheats and can result in fire. The circuit breaker is just doing its job when it turns off a circuit in that kind of condition. Too many appliances running simply means too much current on a circuit.
to prevent a circuit from overloading if too much current flow safely interrupt the circuit if it becomes overloaded
Circuit Breaker
Put too much current through it. Very carefully.
circuit breaker or fuse