answersLogoWhite

0


Best Answer

A fuse is designed to protect an electrical system from too much power. The fuse is blowing because there is too much power going through it. One of the systems that go through that particular fuse line probably has a short.

Just keep in mind, that the gage may not be the problem, but a symptom. Most vehicles share a single fuse for multiple systems. For example the gage could share the same fuse line as the cruise control and if the the cruise control has a short and blows the fuse, you loose your gages too.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why is my gauge fuse blowing up and won't stay on. On a Toyota 4 runner 1994?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Does a 1994 Toyota 4 Runner have a timing belt or a timing chain?

In a 1994 Toyota 4 Runner the ( 2.4 liter four cylinder has a timing CHAIN ) and the ( 3.0 liter V6 has a timing BELT )


What is the transmission fluid capacity on a 1994 Toyota 4 runner?

When doing a drain and fill on a Toyota 4 Runner, it takes about 4.5 quarts to refill. It is important to use the correct type of transmission oil.


How come the 1994 Toyota 4 runner was not recalled for frame rust problems Didn't the tacoma and 4 runner use the same frame?

No, different frame.


Ignition timing on 6 cylinder 5 speed 1994 Toyota 4 runner?

10 degrees before TDC


Where do the two hoses hook to on the bottom of a 1994 Toyota 4 runner?

The radiator?? Theres alot of hoses on a 4runner which engine do you have?


Where is the 1994 Toyota 4 runner fan resistor located?

It's right at the bottom of the blower motor behind the globe box...


What is the average cost to replace a Toyota 2000 4-Runner timing belt?

I recently replaced the timing chain on my 1994 Toyota pick-up. That cost me ~$800 parts/labor.


Does the 1991 Toyota 4 runner come with a rear center brake light and if so where is it located?

center brake lites came out on 1994 4runners


1994 Toyota 4 runner when the oil is cold it reads on the gauge but when it warms up you loose oil pressure what is wrong how do you fix this?

When oil warms up it flows easier and is less thick (has less viscosity). Change your oil and use a heavier weight oil like 10w30 or higher.


Possible causes for over heating of 1994 Toyota 4-runner?

A compression check and cylinder leak-down test should tell you the condition of your engine.


How do you change the drivers side valve cover gasket on a 1994 Toyota 4 runner v6?

how do yo change the drivers side valve cover gasket on a 1994 toytoa 4runner with a v-6 engine


Where is the number 1 cylinder in a 6-cylinder 1994 Toyota 4 runner engine?

Passenger side front of engine. Click the link.