Type your answer here... it is used to find the insulation break down of the conductors from turns to turns and layers to layers.it is aninsulation test for the Transformers
It's double the frequency of the power source.
Frequency doesn't depend on either voltage or current.
The frequency would decrease the gain and increase the output voltage
A: Sometimes a spectrum of frequency must be analyzed a voltage to frequency converter can be used to sweep a range of frequency just by changing some DC level.
no voltage will be induced on the secondary side of the motor as the windings will become saturated.
It's double the frequency of the power source.
A test done on a transformer. The voltage at the power frequency is ramped up to verify the transformer is capable of handling the stresses due to switching and natural phenomena (lighting strikes).Withstand Voltage:The voltage which has to be applied to a test object under specified conditions in a "withstand test" is called the "withstand voltage".
The DVDF (double voltage double frequency) test is an overvoltage withstand test. It is performed by applying a higher than nominal voltage (2 times) to the transformer for a relatively short period of time (usually 1 minute). Since a prolonged (significant) overvoltage will cause the transformer to overexcite, the volts per hertz are kept constant by applying a higher than nominal frequency (2 times in this case).
A sweep test is a method that determines the frequency response of a cable by its generation of RF voltage. This frequency should be varied at a rapid constant rate.
frequency modulation..
voltage and frequency both are different quantity.. don't mix it...
Frequency doesn't depend on either voltage or current.
The frequency would decrease the gain and increase the output voltage
Some test instruments used in electronics are:Multimeter - Used to measure voltage, ampere and resistanceOscilloscope - Used to measure frequency and oscillations
The mains voltage is 230 volts, and the frequency is 50Hz.
the voltage and frequency are 110v and 50(or)60hz because the devices which are invented in us are work at that voltage and it is efficient for that devices.
The frequency is changed by varying its speed, and the the voltage is changed by varying its field current.