answersLogoWhite

0


Best Answer

It depends if you have ecoboost on because ecoboost sometimes slips your gears.

User Avatar

Wiki User

9y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why does your Ford F-150 trans occasionaly slip in drive range?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

98 ford f150 is stuck in 4low anyway to just disengage the 4wd?

If you start the vehicle, put the trans in neutral, then put the 4wheel drive in 2wheel drive, then put trans back in gear it should disengage the 4wd. The 4wd drive is a electronic function. You may have to tap the brake pedal after you have selected 2 whl drive with the trans selector in neutral


What are fixes for code P0705 on Ford F150?

its a bad transmission range sensor its mounted to the trans/its basically a neutral safety switch that has more functions feeding pcm info


Can ford f-150 4 wheel drive rims fit a ford- f150 2 wheel drive?

f150 can a4 wheel drive wheel fit on a 2 wheel drive f150 both 6 bolt pattern


What transmissions are in the ford f150 7700 series?

If the trans code has "u" its a 4r100.All 7700 series came with the 4r100 trans.


Ford F-150 auto trans studder around 50mph why?

My ford f150 auto. trans studder at around 50mph when in overdrive. why?


Where do you add transmission fluid on a 1983 Ford F150?

There is no dip stick on a 3 speed "tree" trans. Trans fluid is added by removing the screw on top of trans casing underneath the vehichle.


What does drive shaft repair cost?

F150 4x4 drive shaft balanced


Will a 1994 Mustang Gt 5.0L motor and trans fit in a 1997 Ford F150?

Yes!


Is the 2004 f150 rear wheel drive?

rear wheel drive or 4x4 capable


Is the 2004 F150 front wheel drive?

No , rear wheel drive or 4X4 capable


Will a 1978 ford f150 4x2 tilt auto trans steering column fit in a 4x4?

Yes it will


2002 4.2 f150 can you swap manual trans to auto?

yes it is easyer to chang that way than the other way just go to junk yard and get trans and stering colum from the same vech. if possible that way the linkage will work no problem also get the drive shaft and any control modules you might need