Air in the pipes from a hole, break or crack somewhere along the line, or from a loose fitting or valve near or at the water heater; possibly caused by a mineral or debris- clogged filter screen at the faucet or discharge end.
Heat speeds up chemical reactions. As corrosion is a chemical reaction, copper pipes at a higher temperature will corrode faster
If you are in a house, with a well, it could be iron in the water. But more than likely you have some pipes or fittings that are old and rusting.
I expect the motor to sputter to life any second, now... The clerk was so exasperated, he could only sputter.
Water is delivered by using large metal pipes.
Well it reacts slowly with water (relative to the other alkaline earths -- but not slowly enough -- your water pipes wouldn't last very long.
Copper is used as hot water pipes because the copper will not corrode when the hot water goes through the pipes
Copper is used as hot water pipes because the copper will not corrode when the hot water goes through the pipes
No this is not necessary. Install the pipes as per usual. You can insulate the hot water pipes up to two meters or up to two yards from the hot water outlet from the hot water tank to prevent this. No this is not necessary. Install the pipes as per usual. You can insulate the hot water pipes up to two meters or up to two yards from the hot water outlet from the hot water tank to prevent this.
Heat tape is just for keeping the pipes from freezing, it does not heat the water. That's what the hot water heater is for.
Your hot water pipes have rust in them.
Well if water is too cold, pipes will contract and if water is too hot, the pipes will expand.
yes
You know it by touching and feeling the pipes on the hot water side; if they are hot, there is water running through the pipes and obviously the heater valve is open on hot side.
The water pipes are full of cold water. All that cold water has to be flushed from the pipes before the hot water from the tank reaches your faucet.
Yes
Water pipes may be covered with foam rubber to stop condensation dripping from the surface of cold water pipes in warm and damp climates, and to insulate hot water pipes so the water in them does not cool while flowing from the hot water tank to the faucet,
There are pipes that feed from radiator to radiator. Or there can be multiple feed pipes and return pipes, it varies based on installation.