Because you disturbed the sensors. Unhooking the battery for awhile then rehooking after about 15 minutes, should reset the computer.
The transit brake warning light, on a Ford, can be reset by changing the brake pads. If the warning light is still on after changing the brake pads remove the fuse for 10 seconds.
The transit brake warning light, on a Ford, can be reset by changing the brake pads. If the warning light is still on after changing the brake pads remove the fuse for 10 seconds.
That warning light means a light bulb is out. Check all of your brake lights (including the brake light on the rear dash!)
No, the license plate light is wired in with the rear tail lights, not the brake lights.
The good news is the brake lights still appear to work even when this warning is displayed. Does anyone know if the brake lights are at risk of not coming on when you hit the brakes?
change the fuse if not replace flasher
broken belt
It is important to pay attention to the warning lights on the dashboard. When the ABS and brake lights flask that means there is something wrong with the brake system.
Most of the light on the dashboard are Warning Lights; different warning lights that might flash up on the dashboard. Some of the more common warning lights are shown below. 1 = Oil pressure warning light 2 = Battery charge warning light 3 = Brake system warning light 4 = Engine warning light
A third brake light is used to provide a deceleration warning to vehicles that can't see the left and right lights. You can learn more about these brake lights at the Wikipedia.
The ABS and brake warning lights will come on in a vehicle when an error is detecting in the he system. This can range from low fluid or pressure to sensor and component failure.
Brake light switch on the brake pedal is defective