0
Why are Seatbelts on dodge ram 2500 stuck in retracted position have disconnected batteries and turn key many times?
Idahoclark
Check under your seats, there is a sensor cable. It maybe disconnected.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Why do you have to put batteries in a certain position in flashlights?
You have + and - on batteries, the polarities have to be in the same direction or the current won't flow.
Why wont your convertible top go all the way up on your 1977 cadillac convertible?
Check hydraulic fluid level Fill with pistons in retracted position
Can the passenger seat belt be released once locked into start position with doing damage?
I bought this car two weeks ago, now the seat belt is stuck in the full retracted position. Can this be released without damage?
When you charge two 6 volt batteries in series is the charger switched to 6 or 12 volt position?
Two six volt batteries in series makes 12 volts so switch the charger to the 12 volt position.
How do you tell if a women is turned on?
Make sure the batteries are inserted correctly and the switch is in the "ON" position
How do i check the timing position on a 1995 GMC 1500?
0 deg -or- TDC With the distributor timing connector disconnected.
How should you store batteries?
Most battery makers say you can store batteries fine at room temperature.We'll accept their position without getting into the debate over refrigeration.
What's the fix for a '91 240SX where the retractable headlights stay in the up position?
if you hear a whining sound when you engage them then they're disconnected from the motors and you need to reattach the arms. no whining means a bad relay, your up down switch is in the on position (or the blue wires disconnected behind it), or you have bad motors. Push the button
How do you fix the automatic seatbelts on a 1990 Toyota Camry when they stop moving?
Well fixing would be hard but try to find the manual override to get the belts moving in a safe position then get it to an mechanic.
Why does the fiesta run perfect when the throttle position sensor is disconnected?
Either it is defective or not getting the right input from the engine control module.
Calitper won't move when putting new brakes on a 1995 lesabre?
The easiest way I have found to do this is to use a "C" clamp on the brake cylinder and slowly squeeze it to retract the piston to the retracted position.
Do you put batteries in a flip video camera?
The latest Flip cameras can use battery packs or 2 AA batteries. Slide the lock for the battery compartment on the bottom of the camera to the unlocked position. The panel should then slide down and lift off allowing access to the battery compartment for replacing the batteries.
