answersLogoWhite

0


Best Answer
Cherokee 4.0 Serpentine Belt TensionerThis engine does not have an tensioner for the serpentine belt. Only the 5.2 liter and 5.9 liter engines have a tensioner. The adjustment is at the Power Steering pump. Just loosen the power steering pump rear mounting bolts, pivot bolt and lock nut and then loosen the power steering pump adjusting bolt. Slip the belt on and tighten the adjusting bolt until you can push the belt in about one inch midway between the A/C and alternator pulleys. Then tighten the lock nut, pivot bolt and mounting bolts and that's it.
User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the serpentine belt tensioner located on a 1994 Jeep Cherokee?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you install a serpentine belt on a 1994 Z71 305 Chevy engine?

Put the serpentine belt on to the pulleys of your 1994 Chevy engine. Tighten a serpentine belt with the tensioner pulley.


Where is the water pump located on a 1994 Chevy Cavalier?

If you have a 2.2 liter 4 cylinder, the water pump is under the alternator on the passenger side and below the serpentine belt tensioner.


Where is the cigarette lighter fuse located on a 1994 Jeep Cherokee?

Where is the cigarette lighter fuse on a 1994 jeep grand cherokee located


How do you change the power steering belt of a 1994 Chrysler LeBaron?

The power steering is driven by the serpentine belt which must be changed by releasing the tensioner, located below the alternator. The only other belt is for the A/C compressor.


How do you tighten the serpentine belt on a 1994 Jeep Cherokee with a 4-cylinder engine?

You can't tighten a serpentine belt. The auto tensioner keeps the proper tension on the belt. If the belt is loose, it has stretched and needs replacing or the tensioner spring is weak or broken and the tensioner needs replacing, or both. . . INCORRECT. . . On the earlier serpentine belts they were tightened much like the old V Belts. For the 1992-1995 Jeep Cherokee you need to loosen the front two "holding" bolts and the rear two or three "holding" bolts on the power steering pump. Then you loosen and or tighten the bolt that is under the powersteering pump, facing toward the outside of the motor. it is almost hidden on the L6 models. That is the way it is done on these vehicles.


How do you replace a 1994 Lincoln Continental serpentine fan belt?

turn belt tensioner clockwise to loosen there is a special tool you can get as loaner tool


Where is the serpentine belt tensioner on a 1994 camaro LT1?

It's on the front of the engine and the belt rides on it's pulley, it's the pulley that you have to release to get the belt off.


Where is the cam sensor located on a 1994 jeep Cherokee?

It is inside the distributor.


Were is the horn on a 1994 Jeep Cherokee located?

Right behind the grill


How do you check for proper serpentine belt tension on a 1994 Jeep Cherokee with air conditioning?

self ajusting idler wheel strong spring inside housing


What would cause the serpentine to not turn on a 1994 Mercury Topaz if all pulleys spin freely when the car is not running?

check to make sure the belt tensioner is functional if not it needs to be replaced


How do you replace belts on 1994 Toyota corolla?

There is only one belt, the serpentine belt. You use a wrench to loosen the spring loaded tensioner and remove and replace, there is no timing belt it has a chain.