Older style tubs have a pressure switch usually mounted directly on the heater manifold, or attached to the Plumbing. The pressure switch is connected to the spa pack/circuit board with 2 wires and shuts the heater off if there is not enough pressure in the heater tube/manifold to protect the heater from becoming damaged or even exploding or causing a fire in a dry heater condition.
Newer spas that use Balboa controls have sensors built right into the heater so a pressure switch is no longer needed as the safety function of monitoring the heater for constant water pressure is now all performed within the heater on newer quality spas.
Yes
Hot tub filters contain sand and gravel to filter our impurities in the water via a high pressure nozzle. The pressure must be high enough otherwise circulation problems may occur.
5 feet
THE HOT TUB IS TO RELAX
You use a hot tub cover after the hot tub has cooled off. Using it while your hot tub is still warm can cause your cover to break.
What about "pool chemicals in a hot tub"?
for a luxury hot tub it is 15,000
Hot tub covers can have long lives if they are cared for properly. Hot tub covers are mostly affected by dirt and sunlight so keep it clean and perhaps put a tarp over it if the hot tub is in direct sunlight.
Hot tub cover prices usually depend on the type of hot tub that you own. Hot tub cover prices can range between $100 to $400. It also depends on your income to decide if a hot tub cover is too expensive.
A hot tub is just that a tub of hot water thus, the need for a heater. To reek the benefits and pleasures of owning a hot tub a heater is an essential element to the experience.
1. Bad pressure switch. 2. Bad pressure switch pigtail. 3. The system is low on freon.
Only during the time in which your are in the hot tub. After leaving the hot tub, all prior weariness will have evaporated.