0
Where is the oil pressure sending switch on a 2001 Explorer located?
Wiki User
∙ 16y ago
On the 4.0 L OHV engine, the oil pressure sending unit is on the driver's side of the engine, located below the Power Steering pump.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Where is the oil pressure sending unit on a 1996 Ford Explorer v6?
the sending unit is located near the bottom of the block on the left ( driver side) it is on the same harness as the oil level switch
Where is oil pressure sending switch on 93 Chevy c1500 with 5.7L?
It is located behind the distributor.
Where is the oil sending pressure switch located for a Lexus LS400 1990?
behind the oil filter
Where is oil pressure switch on an explorer?
On my 1995 Ford Explorer , which has the 4.0 litre EFI , V6 engine , the sending unit for my oil pressure gauge is on the drivers side of the engine below the power steering pump
Where is the oil sending unit located 1988 dynasty?
The Oil Pressure Switch or Oil Sending Unit (which ever you prefur calling it) on 2.5L its located about underneith the Thermostat Housing.
Are the oil pressure switch and oil pressure sending unit the same part?
No, a sending unit is for a gauge, and the switch is for a warning light.
Where is the oil pressure sending unit on 1996 gmc suburban?
The oil pressure sender or switch is located at the rear of the engine, behind the distributor.
Where is the oil sending unit on a 2005 dodge magnum?
The Oil Pressure Switch (Oil Sending Unit) is located on the rear of the motor towards the top. The crank sensor is located next to it if that helps any.
Where is the oil sending unit on a 1988 Chevrolet celebrity 2.8L v6 located?
The oil pressure sending switch on a 1988 Chevrolet Celebrity with 2.8L V6 is located on the bottom of the block near the oil filter.
Where is the oil pressure sending switch located on a 89 Beretta 2.0?
within three inches of the oil filter, it has three wires.
Where is the oil pressure switch on a 2000 ford explorer 4.0 liter?
The oil pressure sending unit on the 4.0 L OHV engine is on the driver's side of the engine located below the power steering pump and looking at the picture in my Haynes repair manual it looks like the oil pressure sending unit on the 4.0 L SOHC engine is mounted low on the front of the engine slightly below and to the right of the lower rad hose to water pump connection when you are looking from the front of the Explorer.
Where is the oil sending unit located on a 1999 town car?
I assume this is the oil pressure switch. It's located on the oil filter housing. Unplug the connector and unscrew it.
