answersLogoWhite

0


Best Answer

== == Hi, most cars these days have the fuel sending unit and fuel pump located together inside the fuel tank.....because the fuel sender has stoped working the overhead display will not work either...hope this helps... Hi, I have a 2001 with a similar problem. I just reset my trip meter every time I gas up, and also the overhead console where it shows fuel used, although it is usually off by anywhere from 5 - 15 litres. I know that once I hit 500 kilometers, it is time to llok for gas. This is using trip meter A, trip meter B I use for last oil change, because the oil level number will let you go to about 6000 kilometers before getting down to 50.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the fule sensor located- The fuel Gauge stays on full and the overhead readout is also not working?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the dual overhead cam located on a 2002 ford escort zx2?

Where is the dual overhead cam located or the air temp charge sensor?


Where is the sensor for the outside thermometor readout located on a 2002 Buick LeSabre?

It's called "ambient temperature sensor" and is located between the front grill and the radiator. It is slightly to the left of center of the hood latch.


Where is the sensor for 1998 explorer overhead console?

The temp sensor is located behind the bumper, below and to the left of the driver's side headlight.


Where is the outside temp sensor located on a 1997 dodge ram the one that controls the temp display on the overhead console?

The outside temp sensor is located on the passenger side of grille by radiator


Where is the outside temp sensor for overhead display located on a 2001 Chrysler Town and Country?

It is behind the front bumper, in front of the radiator.


Where is the coolant temp sensor for the dash gauge and climate contol on a 95 cutlass supreme and is diff from usual mechancic's readout sensor for eng temp and radiator fan control?

May be located in the head nearest the firewall on the driver's side. That's where it is on my 95 3100.


How do you locate the door sensor that controls the overhead light in the cab of a 1998 Ford Ranger?

The sensor is intergrated into the door latch. If it is not working (and the door chime stays on) spray it with WD 40. This almost always works.


Where is the speed sensor located on a 2004 Chrysler Concorde lxi?

There are two speed sensors, an input and output. They are located on the transmission. If the problem is the speedometer not working it is the output sensor located on the driver side of the rear of the transmission.


Where is the intake air sensor located on a 92 Saturn duel-overhead cam?

The air intake sensor is located in the air tube connecting to the air cleaner box. The tube runs driver's side to passenger's side at radiator location and is on the bottom side of the tube. Make a note.....the coolant temperature sensor and air intake sensor are the same.


Where is the outside temp sensor on a 2002 gmc envoy the one that reads outside temp for the rear view mirror readout?

The Ambient Temperature Sensor is located behind the grill and mounted to the radiator support with a "push in" connector. Remove the screws that attach the upper portion of the grill and pull the grill away from the vehicle enough to access the sensor.


What is the device under rear view mirror of ford expedition?

The device under your rear view mirror ( if your referring to the oblong shaped black plastic box about 3 inches long...) Is the sensor for the overhead directional read out. If you have that box then you have a digital readout on your overhead console that tells you basically useless info that is barley accurate like... North South East and West and your average miles and gas mileage. The black box is for the North . South ect, read out. It senses your direction. Mine stopped working a while ago and was never right. It can be reset by means of a little hole in the bottom of it by inserting a paper clip and gently pushing the reset on it. it is not usually accurate but removing it will mess with the whole readout. I hope this helps Steve in Pa .


Where is the overhead cam sensor located on a 1997 explorer v6 xlt and is it hard to get to?

On the 4.0 SOHC V6 it is located on the left valve cover near the engine oil filler cap. On the 4.0L pushrod it is located at the rear of the engine block.