open glove box drop down door, look thru hole to the left and up
Actually, the actuator motor on the Expedition/Navigator is located on the bottom of the heater box above the transmission tunnel. You have to remove the console and various trim pieces to get to it. Check the information on www.heatertreater.net for pictures and diagnostic information. I have also posted information on this forum that will help answer questions about the Expedition.
cgallen
Actually the 2003 model has a different dash layout and heaterTreater only has info on the 97 thru 2002 models. I contacted them and they said they will have diagnostic info and products for the 2003 and later models sometime in spring 2010.
-dstaker
The actuator is on top of the heater box. I am in the process of replacing it now, on my 2003 Expedition 5.4L and am finding it to be quite involved! so far I have the middle console out, the glove box out, and some of the dash off. I found that there is a cross beam for the dash frame that is in the way. That is as far as I have gotten. Good luck to those attempting this!
cbeh
i think its above the diff
How do i replace blend door motor
In the back/middle
Generally the problem is with a broken blend door, not a bad actuator motor. A solution is available at www.heatertreater.net and additional information can be found by checking my other posts on this forum. cgallen
You don't!
The Expedition uses the same HVAC system as the Ford F150 pickup truck. The Expedition is a little tricky because you have to remove the center console and floor heat distribution vent to access the actuator motor. Once you remove the motor, you can examine the blend door axle for cracks or breakage. This is a common fail mode on the Expedition. HeaterTreater is the world's leading company for aftermarket blend door fixes and has a product for the Expedition. Additional diagnostic information and pictures are available on the Ford Expedition HeaterTreater Ebay listing or the web site at www.heatertreater.net. There is an inexpensive effective fix available that replaces the cheap plastic door with steel that will outlast the vehicle. cgallen
The switch can be found under the dash on the passenger side of the vehicle, closest to the door.
how do you get the entry codes for expedition eddie bower
wd40 in all door latches and strikers.
under the pedals
under the glove box
I believe it is located behind the glove compartment. Drop out the glove compartment box and you will see the blend door actuator.