The check engine light (service engine soon) comes on and stays on when a problem is detected by the self diagnosis system of your vehicle. Generally, the problem is in the emissions or something that is affecting the effectiveness of the emissions, but other causes can trigger the light to come on, too. To determine the cause, the vehicle will need to be taken to AutoZone or a shop that has an OBD2 scanner, or for 1995 and earlier models, an OBD1 scanner, While a scanner will not give you the magic answer, it will give you a code that narrows down the problem area.
The check engine light would come on.
First uf all, The computer has nothing to do with the 4x4 on this year truck. If your check engine light is on , Then there's a problem in the system wiyh the engine or transmission, Not the 4x4. You need to check the 4x4 Actuator on the front housing to see if it has power going to it when you ingauge the 4x4. Check it with a test light. If it lights up the test light, Then replace the actuator in the housing. If it don't. Then go to the top of the Transfur case and you will see a switch on it. Check it with a test light, With the 4x4 ingaged, if its hot there then replace that switch. Before you do anything check the 4x4 Fuse's in the fuse box with a test light.
I dont know but i have a 88 & i think the trans in mine is slipping. My check engine light came on
There is no "fog light sensor".There is no "fog light sensor".
i have a 1994 geo tracker and i asked the guy at autozone about this. he said that there is a sensor that makes the light come one. you have to disengage the sensor to make it go off. take it up to autozone or any auto shop that does free work and have them do it. 1991 Geo Tracker 4x4, engine will turn, but will not start.
See link below.
There is no "knock sensor" on a 4.0L engine
Sounds like you need a tune up. New spark plugs, air filter, oil change. Check your distributor cap and rotor. Might even need a new MAF sensor for the check engine light. Get a manual and go through these ideas.
its normal for the ck engine light to be on during this time as it is running it engine cks
NOTHING, It must have the 4L60E in it are you will have a check engine light on and always heve performance problems.
Need to put truck in 4x4 with engine off, transmission in park key onTake a test light and check the wires on the Actuator, and see if they are hot.If they are hot Then replace the 4x4 Actuator in the front housing.If they are not, Then check the 4x4 fuse
this indicates that the 4x4 is ingaged or that the sensor think that it is. if you have a push button 4x4 most times it is not disengaging from 4x4 try going backwards a few feet after taking it out of 4x4 mode to see if this does not help .