It is in the top rear of the bell housing,
No. The engine won't run with a faulty crank sensor.
The Crank sensor is located on the transmission housing near the top at the back of the engine.
On a 3.0 liter v6 the crank sensor is located on the bell housing of the trans.It has a wire coming out at the top right of bell housing. The cam sensor is in the front of the engine near the serpentine belt.
A bad cam or crank sensor can cause a no start, but the engine will still crank or turn over.
Yes, a crank sensor is one of the major sensors used to control engine timing and cylinder firing.
It does not have a crank sensor, it only has the "pick up" plate in the distributor.
i think u mean crank sensor and that would be by the dampener or balancer in the front of engine (near crankshaft)
Crank sensor is in the top of the transmission housing at the back of the engine. Cam position sensor is in the distributor.
No crank sensor, only the sensor in the distributor.
4 cylinder : back of the block 6 cylinder : top of bell housing, about 2 0'clock if looking over drivers side.
The Chevrolet Corsica 3.1 liter engine crank sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crank sensor.
The crank sensor is located at the left front of the engine