Look on the distributor cap there is a plug in for your tach.
AnswerThat is not correct.... you will need to hook up four wires, actually three to make it work, but four will get the lights working too. Start by locating a good chassis ground and connect the black tach wire to it. The red tach wire needs a 12V positive source that is activated at the acc and run position of the key. To locate this, use a multi-meter or test light and check by turing key forward and backward, looking for power when key is forward in the first spot, or accessory spot, and the run spot (where the key sits when the car is running). The green wire from the tach goes to the ground side or ground wire of you ignition coil you will find this on the drivers side inner fender, under a black cover where the center distributor cap wire is connected. The white wire from the tach goes to a power source that has 12 V positive when your parking lights are activated. You can find this by removing your headlight switch using a small flat headed screw driver (two clips) and look for a small brown wire that has power when both parking lights and head lights are on. This should set you up nicely....You Can Put a 1988 Transmission In a 1993 Mustang Body.
Mustang Software was created in 1988.
220 horsepower for the high output 302 in a 1988 Ford Mustang
The horsepower in the 1988 Ford Mustang 5.0 was 225 horsepower
How to put manual transmission on mustang 1988
The horsepower on the 1988 Mustang was # 90 horsepower 2.3 liter engine # 225 horsepower 5.0 liter engine
It certainly ought to.
R12
Depends on how old and how the older one was equipped
The gear ratio for a 1988 Mustang is 3.45:1 on a standard (four) and 3.73:1 optional (four)
Yes they will bolt down with no modifications
225 hp