If it has a distributor it doesnt have a crank position sensor. The magnetic pickup in the distributor is what you would be looking for. The module is either on the side of the distributor or on the firewall against the drivers inner fender.
What position is the crank sensor on a f250 ford pickup
The crankshaft position sensor is required and can not be bypassed.
Follow the front wire on the distributor and it will lead to the crank shaft position sensor. hope this helps..
where is the crank sensor located at on a 1996 cutlass ciera wit a 3.1 engine
DOWN BY THE OIL FILTER EASY TO DO
no
It is located on the distributor under the cap and rotor Crank sensor should be on the front bottom of engine by the crank pulley
There is a tone wheel on the crank/flywheel that the sensor reads off of, if that is your question.
The dealer sells a cardboard spacer the glues to the tip of the crank sensor. You then install the sensor and push it tight to the flex plate.
by what i understand its located between the crank pully and block.
The crank sensor is located on the bell housing of the transmission on passenger side. You will need an Allen wrench.
the cranck sensor is on front of engine it reads the teeth on crank pulley.the cam sensor is on top of same side of engine.