Didn't note when this was posted... I'll answer anyway; 1987-88 3.0s came with 52mm units as did the 3.3s (NON-LH) and 3.8s. The early 3.8s had 58mm TBs but they are very difficult to find. For my '93 I had to cap the two vacuum ports on top of the TB as they were not connected like the earlier models. The LH (Intrepid, etc) TBs are VERY different and more or less not interchangeable.
in a graveyard smat one.
yo leg, mane.
Abdomen is under your chest. That is very important.
She was cremated and scattered at sea.
1. find the body 2. wrap it up 3. put it in the tomb
It is on the throttle body, opposite of where the cables attach.
The throttle cable does not go from the transmission to the throttle body.
It is located on the bottom of the throttle body. You can find the throttle body by following the two big air pipes from the air filter box, they end at the throttle body. To access the throttle position censor you must remove the throttle body.
by cleaning it
The throttle body is where the air goes into the engine. Find the air filter, then follow the plastic duct over to the throttle body. It is round and made of metal.
The throttle body is not adjustable.
Look on the throttle body opposite of the accelerator linkage, most of them are there.
Should be located on the throttle body
online
The throttle position sensor is on the throttle body. That's the part of the engine that controls the amount of air allowed into the engine. To find the throttle body, follow the air intake routing toward the engine. The throttle body is the part that sits on the intake manifold. To find the throttle position sensor, follow the throttle cable to the throttle body. If it helps, have someone press down and release the throttle pedal while you're looking for the throttle body/position sensor. The throttle cable causes a shaft to turn, that's the part that controls the air coming into the engine. The throttle position sensor is connected to that shaft.
Check the throttle body over carefully to find the leak. If a gasket is leaking then a new gasket set will stop the leak. If the body has a crack then you will need to replace the throttle body.
A fuel injector pulse is the product of an electrical charge controlled by the ecm to briefly open an injector. If the engine is throttle body injected, you would find the injectors in the throttle body.