Where are the cam seals on the 97 Plymouth Voyager?

already exists.

Would you like to merge this question into it?

already exists as an alternate of this question.

Would you like to make it the primary and merge this question into it?

exists and is an alternate of .

3.0 Liter six Cly Plymouth

1 -remove passenger side tire
2 -remove black rectangular plastic cover
3 -take the bolt out of the harmonic balancer and pull off
4 -un-bolt the a/c compressor and hang it in place with a bungee cord
5 -put jack under the engine to hold in place and remove the right side motor mount from inter fender
6 -take the 3 bolts out of the idler pulley & remove
7 -take the 5 bolts out of the motor mount attached to the engine & remove
8 -un-bolt the plastic cover that covers the crank and cam pulleys (gears)
9 -turn the tensioner pulley that holds the timing gear in place
10-take off the timing belt
11-remove the cam pulleys - seals are located behind pulley (gears)
12-remover the crank pulley (gear) - crank seal is located behind
4 people found this useful

How do you remove the headlights on a 97 Plymouth Grand Voyager?

Answer . I doubt if you need to remove your headlights. Mine were extremely dim and I considered replacing them, but instead I bought two bottles of cleaner and polisher. C

What are the wire connections for a radio of 97 Plymouth Voyager?

Answer . \ndude, if you are putting in a new deck just by a wiring harness from a parts store, audio video store, radio shack or even walmart. do not go through and try t

How do you know if your alternator is bad on your 97 Plymouth voyager?

When the battery light stays on or flickers. If you have a voltmeter, you can check voltage at the battery. With car off, should read 12 volts. Running, it should be 13 or 14

How do you replace serpentine belt on 97 Plymouth Voyager?

3.3L and 3.8L Engines . note: It is best to use serpentine belt tool kit.. All of the belt driven accessories on the 3.3L and 3.8L engines are driven by a single serpentine

How do you change water pump 97 Plymouth grand voyager?

I have a 1998 Chrysler Voyager and to change the water pump I foundthat after loosening the bolts there was simply not enough spacebetween the engine and the engine side wall