0
When should the timing belt be changed on a 2000 Chrysler Sebring convertible?
Wiki User
∙ 9y ago
Every 100,000 miles.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
When should the timing belt be changed on a 1999 Chrysler Sebring Jxi convertible?
60,000 miles. This is an interference engine. If the belt breaks you will have serious engine damage.
When should you replace the timing belt on a 1999 Chrysler Sebring JXi Convertible?
100,000 miles
What type of oil should be used in a 2004 Chrysler sebring convertible?
5w30 but it depends on the size of your engine.
How long should labor take to replace a water pump in a 1996 Chrysler Sebring Convertible?
6 hours
Where is the jack and lug wrench located on a Chrysler Sebring convertible?
They should be under the floor in the trunk, with the spare tire.
Where is the dipstick on a Chrysler Sebring?
For a 1997 Sebring Convertible the oil dipstick is located just left of center towards the front of the car and should be labeled "engine".
How much should front and rear struts and shocks cost for a 2002 chrysler sebring convertible?
How much a front and rear struts and shocks cost for a 2002 Chrysler Sebring convertible varies based on the store, and brand of the part. In general, all together the parts can run $200 to $400.
What is the gas mileage for the Sebring Convertible?
Depending on how the car is drivenand which convertible, mileage can vary. But, according to Chrysler, this car should get 20 mpg in the city and around 27 on highway.
How often should the timing belt on a 1997 Chrysler Sebring be changed?
Every 100,000 miles.
What should the normal idle be on a V6 Chrysler Sebring Convertible at stop or rest?
The computer will set idle between 600 and 900 rpm depending on load and temperature..
How do you replace the rear rotors on a Chrysler Sebring convertible?
This change out should be fairly easy (compared to the front rotors). I changed out the rear rotor on a 2000 Sebring Convertible rather quickly. Buy the rotor at Autozone or o'Rielly and you will see that it justs slips over the lug nuts. The old one may take a little tapping around the edges to loosen it up. Use a gear puller in a worst case scenario. RB in Houston
Will 22 rims fit your 1997 Chrysler sebring convertible?
You may have to go to an auto parts store, they have mechanisms that you place between the springs to give it a small lift. If you do this, it should work with no problem.
