answersLogoWhite

0


Best Answer

It should be almost to the wall. When the tub is in place you'll be installing the drain and overflow. You'll then connect these to a p-trap and all of that will be connected to the roughed in drain. Give yourself a little room to work, and cut the concrete back to give yourself room to get in. You'll do the connecting from the end of the tub, so also make sure you have access. When it's all over, some city building and zoning departments are requiring that you pour concrete to seal off the exposed ground under the drain.

User Avatar

Wiki User

18y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: When roughing in plumbing in a basement bathroom how far from the wall does the drain need to be for a tub?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Can you install a toilet from your washer plumbing in the basement if there is a drain?

If the drain is adequate size, 3inch, then you could.


Can you build a bathroom or kitchen without any sloap or pitch?

Bathroom or kitchen should be square and level. The plumbing drain lines need slope to drain properly.


What is a pop-up in a plumbing drain system?

The plug in a bathroom sink that you open and close with a rod that is in the faucet.


What type of drain cleaning equipment would be best suited for a residential bathroom plumbing project?

Kyna-Colt Kinetic Pulse Cleaning System would be best suited for a residential bathroom plumbing project.


Do you need a drain in the basement in order to install a home water softener in the basement?

Depends upon the plumbing code in your area.... A traditional ion-exchange water softener does need a "drain line". Typically 10-50 gallons of water are sent to the drain during each regeneration . Depending upon the local plumbing codes this drain could be: - a floor drain - a deep-sink drain (wash basin) - plumed directly into the household sewer drain (typically this installation uses a device called an air-gap)


Hanzel Plumbing & Drain Cleaning?

Hanzel Plumbing & Drain Cleaning


Mike Plumbing & Drain Service?

Mike Plumbing & Drain Service


Unclog Your Sink With A Plumbing Snake?

Clogged drains in the kitchen and bathroom can prove to be a problem. After you have tried liquid drain cleaners with no luck, try a plumbing snake. The snake is inserted into the drain and goes only a certain depth. If there is any kind of clog into the drain, it will either push it through the plumbing system or you can pull the clog out with the snake. Make sure that you are using the end of the plumbing snake that has the small hook on the end so you can easily pull anything out of the drain that may be stuck in it.


How do you identify a sewer gas smell in basement bathroom?

Most likely a drain has dried out and there is no water in the trap to stop the gas from coming up. Sink, shower, or main floor drain.


What causes gurgling in one bathroom when another bathroom is used?

A vent for the drain system may be blocked. A home or building plumbing system must be "free flowing" with a vent to the outside atmosphere - usually through the roof. When water is forced down the drain and the vent for that drain is blocked, air will be pulled from inside the building through another plumbing fixture causing the gurgling sound. The main drain line may also be partially blocked whereas when water is forced down the drain the air in the drain line may be forced back into the building through another plumbing fixture causing the gurgling sound.


Basement Drain Repair?

form_title=Basement Drain Repair form_header=6903 How would you describe the interior channels you need to have repaired?*= () Plastic channels behind baseboard () Channels dug into concrete slab () Covered channels buried in slab () Don't Know How would you best describe the problem?*= () Channels can't handle water volume () Channels not sloped properly to drain () Channels drain to faulty sump pump () Channels are clogged () Bad odors () Requires cleaning/maintenance


Does the Ontario plumbing code allow a U loop in a vent line for a basement bathroom to get around a heating duct?

No plumbing code allows a loop in a vent line. They must be pitched just like a drain line as there are many conditions where water can be in a vent line, such as rain through a roof vent and condensation. If the "u" were to fill with water it would no longer function as a vent.