When it needs to provide clocking for the serial line. This occurs when you are using a null-modem cable in a lab. You would apply the clock rate to the router that is connected as the DCE device.
You should configure the clock rate at the DCE device. ALWAYS
The routers will not work right if you forget to do this.
only to configure it, after that, no.
UBAMA(config)# interface FastEthernet 0/1Use this UBAMA(config)# interface FastEthernet 0/1 to correcty configure the connection.I Hope this could help. And also online pc repair if your having problems in yourComputer, Fast and reliable accurate service from the exact moment you need id
a router is a device which need to be configured b4 online. Router configuration means What the router should do for us. it is a program containg the ip address the subnet mask the hostname ..
At least you will need a router even if you have a modem.If you get the router from your provider, all the configuration may be done automatically.If not, it may be possible that you have to configure the router by yourself. In this case it needs the credentials in order to get access to the internet. How to configure the router is explained in its user-manuals.a DSL/cable router
At least you will need a router even if you have a modem.If you get the router from your provider, all the configuration may be done automatically.If not, it may be possible that you have to configure the router by yourself. In this case it needs the credentials in order to get access to the internet. How to configure the router is explained in its user-manuals.a DSL/cable router
Most likely you do not. What you need to do is to configure it properly.
You will need to connect your PS3 to a router, and the router into your broadband modem. You may need to configure port forwarding for your games to work. Go here: http://www.portforward.com/english/routers/port_forwarding/routerindex.htm for a list of routers and how to configure port forwarding.
You plug your wireless into dsl router (you'll need to configure your router), and then configure your computer to the wirelessJust get a lan cable which is usually ships with wireless routers. Connect one end of the cable in wireless router port which is called wan or intertet. Another end of the cable connect to your modem. Then restart the modem and the router. Sometimes you might need to change settings for internet coneection and DHCP server. But usually it's not required.
To connect to a cisco 1800 series router, you need either a network connection that goes to the router, and then you would configure the router to allow telnet or you would need a console cable, also called a rollover or cisco cable and physical access to the device.
If you want to shutdown a port on a Cisco 2960 Catalyst Switch you will need to connect to the router (either SSH, TelNet or connect using the Console cable) and enter the interface you want to shutdown. You will then need to enter the shutdowncommand. An example is given below for Fast Ethernet 0/2Router> enableRouter# configure terminalRouter(config)# interface fa0/2Router(config-if)# shutdown
You need the alert monitor to configure and store the alert data which is recorded by the snort sensor.
Well first, make sure you have everything you need at hand: the router, the computer, the instructions. Then, connect to the internet, connect the router by following the instructions, configure the router and connect your vices. Your instructions should be your biggest guide through this but if you still need help, go to www.microsoft.com for further help.