ANS- a dc component, VL(dc) = VLM/π FOR HALF WAVE RECTIFICATION.V(dc)=V(average)
In most circumstances a full wave diode bridge is used to convert AC into DC. Along with inductors and capacitors used as filters, the DC ripple is smoothed out to a very stable DC voltage. This is the method used in DC power supplies. To convert from DC to AC an inverter is used. Today most inverters use the modified sine wave method which brings the sine wave closer to a AC generated sine wave. Older inverters used an on - off switching procedure to generate a square sine wave. Modern electronics do not work well with square wave generation.
Washington DC or Washington State? Either way, immigrants from SEA commenced about 1975.
An offset AC wave. It will be offset by the magnitude of the DC applied.
mainly AC but can be DC if done correctly
A: BEST HOW? the input power does not change for full wave or half wave rectification The output of a half wave will have half of the power available for the output to use so it would be best a low DC requirement yes.
It does not have to be. Voltage can be DC, sinusoidal, square wave, triangular wave, etc.
If its a triangular wave, its not DC, its AC, its just not sinusoidal. Can a transformer operate on triangular AC? Yes, but not as efficiently as on sinusoidal AC.
It is smoothing
convert AC to DC
A: ANALOGUE IT can be AC or DC it is up to the application involved An analog signal can be a sine wave, a square wave a sawtooth wave or any other varying waveform
The wave with the maximum RMS value, in comparision with the peak value, is the square wave.