It has to be the switch. It is what controls the power to the wiper motor. If the switch is fried again I would check that the relay (or that the fuse is the right amperage) has been fried in the open position somehow. This would allow unchecked voltage to fry its way through your switch to power the motor. I hope this helps you some.
The swith
sounds like you should try and replace the relay and see if works after that. could be a switch.
The light in the switch can not be changed, the whole switch would need to be replaced.
To replace the brake light switch on a 1995 GMC Sierra 1500, the steering wheel will have to be dismantled until the brake light switch is reached. The switch is changed by unplugging it and plugging in a new one. There are screws holding the switch in place.
Possible defective brake light switch. These have been intermittant for several years. There was a recent recall for certain model years for this item.
As this is an intermittant problem it is more than likely the brake light switch is sticking at times..
How do I replace the windshield wiper switch?
You do not need a key to replace the ignition switch.
How do you replace the hazard switch
replacing the volume control switch on 2008 flhx how to replace the volume control switch on 2008 flhx
Ignition switch 2002 Chrysler sebring. Original key will not turn? Is there a fuse or replace the switch?
2001saturn l200 how to replace a windshield wiper switch