answersLogoWhite

0


Best Answer

The original score is by Alex Wurman and I don't know if it is available. It can be found if you search "Lice" by Alex Wurman.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What song is played during the closing credits of the movie the switch?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Music & Radio

Does Ashley Tisdale sing in aliens in the attic?

Yes she doesn't sing in the movie but at the end when the credits are rolling she sings a song called Switch. Hope this helped :)


I have 2000 Jeep Wrangler with No Brake lights. Replaced Fuse and both brake light bulbs. Still no brake lights. Tail lights Blinkers and Back up lights work. Any Ideas Thank you very much.?

Although there could be other causes, I suspect that the problem is related to the brake light electrical circuit since you replaced the lamps and fuse [assuming they were all good]. The most common cause of symptoms that you describe suggest that the brake light switch may be involved, either not adjusted properly, or defective. Though not familiar with your vehicle, MOST brake light switches are mounted on or near the steering column, and above the brake pedal arm, in contact with and depressing the switch's plunger [thus holding the switch OPEN], and when the pedal is depressed, allows the switch plunger to extend, closing the switch, allowing electrical current to the circuit and thus the brake lights. This type of switch is genrally mounted by screwing a threaded nipple on the switch into a threaded hole in a mounting bracket. This switch is adjusted by screwing the switch further out or in. A small percentage of vehicles use a hydraulic type switch mounted into a hole on the brake master cylinder on the firewall in the engine compartment. To my knowledge, these switches are not adjustable. Good luck.


Were is the running lights switch on 92 Jeep Cherokee?

The switch should be the same as your headlight switch. If not then you will either need to install your own switch for the running lights or buy a new OEM switch module.


What is a push to brakes switch?

A push to brake switch is a switch were it cancels out the circuit so that the electricity cannot flow through the circuit.


How do you switch on parking lights?

The rocker switch on top of the steering column.

Related questions

Does closing a switch allows electrical charges to flow in a circuit?

Closing a switch makes a closed circuit Opening a switch opens, or breaks the circuit


Does closing a switch allow charges to flow in a circuit?

Yes, that's basically the purpose of a switch.


What is a Device that makes connections within a telephone network by opening and closing electrical circuits?

switch


What do we call the sort of connection you make by closing that switch?

open circuit


When does electricity start to flow?

When the electrical circuit is completed - usually by closing a switch.


Will I be able to transfer credits from trade school if I switch to a four-year college?

Some of the credits will be transferable. You will need to ask a counsilor at the college if all will be.


You were going for a Bachelor degree but want to switch to associates and you have over 60 college credits?

This would depend upon your college's guidelines and what subjects your credits were in. Consult with your school counselor to be sure you maximize your credits.


How do you remove the window from the screen without closing it?

You could minimise it, which technically isn't closing it, or you could switch to another window if there was one open. Alt-Tab will do that.


How do you flip the switches in the electrical room?

When ever a safety switch is thrown, be it to the on position or the off position, the operator must stand to one side of the switch. It is during the act of opening or closing a switch that a fault could occur. If a dead short occurs when doing this action the whole switch could explode. If the operator is standing in front of the switch their body would take the full force of the explosion.


How does removing bulb or opening and closing the switch affect a series circuit?

Removing a bulb - or opening the switch - breaks the flow of current in a series circuit.


What movie and television projects has Marco Musienko been in?

Marco Musienko has: Played Hajo in "Switch reloaded" in 2007. Played Silbereisens Liste-Sprecher in "Switch reloaded" in 2007. Played Der Pate-Sprecher in "Switch reloaded" in 2007. Played Sat.1 Filmfilmchen-Sprecher in "Switch reloaded" in 2007. Played Die Petra in "Switch reloaded" in 2007. Played Die Witzewelle-Sprecher in "Switch reloaded" in 2007. Played Die Zipfelbuben-Sprecher in "Switch reloaded" in 2007. Played Franjo Pooth in "Switch reloaded" in 2007. Played Einer der Anderen in "Switch reloaded" in 2007. Played Supertalent-Regisseur in "Switch reloaded" in 2007. Played Alexander Klaws in "Switch reloaded" in 2007. Played Heute journal-sprecher in "Switch reloaded" in 2007. Played Der Exorzischt-Sprecher in "Switch reloaded" in 2007. Played 5 gegen 5-Sprecher in "Switch reloaded" in 2007. Played Joey Tempest in "Switch reloaded" in 2007.


Why does my clothes drier have an Electrical hum when I turn it on but doesn't work?

the starting switch on the motor not closing properly