0
What size wire should be use for connecting a 110 kw motor over a distance of 108 meters?
Wiki User
∙ 12y ago
This is a voltage drop question. To answer this question a voltage must be given.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you work Dol starter?
A DOL or direct on line starter works by connecting the motor terminals directly to the power supply when they are energized. A DOL starter is the simplest type of motor starter.
How starting torque of an induction motor can be increased?
For a single phase motor, this can be done by connecting a capacitor in series with the starting windings. For three phase motors, this can be done by connecting starting resistors in the stator windings at starting. This reduces the stator current and hence it's flux density. Thus the rotor will have less opposition starting to rotate. Hence, the torque has increased.
What measures should you take in order to rewind a motor for three phase?
Remove the motor from the system. Get the motor rewound at a motor rewinding shop. Replace the motor back into the system. While the motor is at the rewind shop find out why the motor burnt out. The first thing that should be checked is the overload protection. Make sure that is is the same as the motors full load amps.
How do you slipring motor is convert to inducton motor?
With a synchronous motor shorting the slip-rings together should make it work as an induction motor although perhaps not to an optimal degree.
Is the black wire connected to the line or the grounded line when connecting a power cord to a motor?
Black is the hot side of the line, white the neutral side, green (or rarely bare) wire is the ground.
What is the maximum distance a lt 200 kw motor can be run from a ltmcc?
40 meters
What should be applied to each threaded connecting rod bolt?
Motor oil in small amounts
Where are motor mounts located?
connecting motor to frame on bottom left and right of motor.
What is the maximum distance that a 60-watt motor may vertically lift a 90-newton weight in 7.5 seconds?
5.0 meters
What can cause the connecting rod caps to lock up the motor?
The connecting rod caps can lock up the motor if they are installed backwards. This makes it important to mark the connecting rod caps when removing them to prevent this problem from happening.
Neuron connecting sensory and motor neurons?
interneurons
What might cause the motor to tap?
A stuck lifter or loose connecting rod.
What part of a DC motor on the armature is responsible for connecting brushes to a coil?
commutator
What is the main function of a connecting neuron?
To take the signal from the sensory neurons to the motor neurons or other integrative neurons
To make a homemade vehicle that will travel 1.5 meters what should you do?
If it hasn't got a motor - push it. Just make sure you have wheels on it.
What is the Connecting rod torque specs for Nissan z24 motor?
36 foot pounds
Is a motor an input or output?
The monitor is an output device......
