answersLogoWhite

0


Best Answer

I ha dthis very same problem and couldn't find anything. I replaced the headlight switch twice and while I was trying it the second time I turned the switch on and off and it worked!? What I discovered is that it wasnt the switch itself but the plug that goes into the switch. It wasn't making a good connection or plugging in tight anymore therefore not working. I wasnt in any mood to go buy the wiring harness for that and route it through as far as it goes and it just looked like a pain because I couldn't see where all the wires went without tearing the dash apart so I turned the wires onto the switch where it worked or made contact. I then used Duct Tape to hold it in place to make the connection and I haven't had trouble with it in more then 5 years now.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What needs to be checked when your tail lights as well as your dash lights and brake lights the headlight switch has been changed and the fuses and bulbs are all good in a 98 Ford Contour?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What would cause the signal lights to not work in a 1995 Ford Contour?

have you checked the fuses?


How do you turn on the fog lights in a 1998 ford contour?

With your low beam headlights on , pull the headlight control towards you


Why would the tail lights on a 1991 Ford Probe not work when the turning and brake lights do?

check all of the fuses.if they are ok, check the bulbs. If ok, have the headlight switch checked out. My dad has a 95 contour that had the same problem the tail lights and interior lights went out. There was some switch( I believe under the dash) that controled it, that had to be replaced by ford. I found this question actually looking for it because I had the same problem with my 93 Ford Probe. I tried everything. Changed fuses in car, checked bulbs, checked wiring, changed the brake light switch. Nothing worked. Finally figured out it was VERY simple problem!!! It was a fuse under the hood. There's a fuse box under there that I didn't even know of for a while. When I changed it I didn't even know if that was it and IT WAS. Now my dashlights and tail lights work. GOOD LUCK!!


What would be wrong with the Daytime running light that don't work on 91 Plymouth acclaim Changed relay under fender checked fuses checked E brake?

If the headlight that runs through the modulator first is out then the daytime running lights won't work. Change the bulb and the daytime lights should then work.


Why are the taillights and gauge lights out on a 1989 Chevy Blazer?

About the only thing they have in common is the headlight switch. Have it checked out.


How do you get the interior lights and the lights in the dashboard of a 1994 Geo Tracker to work all of the fuses have been changed?

change the headlight switch !


If the dashboard and tail lights don't work could it be the headlight switch on a 96 ford contour?

From my Experience most of the time its a fuse that is blown. The dashboard and tail lights run off the same fuse


1996 Ford Contour what would cause the dashboard lights to not come on?

Check fuses? Could be a bad headlight switch/ Could be an open in dimmer rheostat?


What would cause both fog lights not to work on '99 Beetle already checked fuse?

Pull out slightly on the headlight switch. If the fog lights do not respond you need to replace the switch.


Why wont the daytime running and low beams lights work when I have high beams and have changed both lights and the switch?

Have you checked the drl relay?


How do you adjust the headlights on a 2003 Mitsubishi Galant GTZ?

I have changed the headlight but I need to adjust it as the lights don't hit the road


How do you get your 96 Ford Taurus headlights to go out when you checked the fuses and had to disconnect the battery?

You more than likely need to replace the headlight switch. Lights not going out when turned off is a symptom of a bad headlight switch.