The type of oil one can use in a 1993 Oldsmobile Cutlass is either 10 W 30 or 20w-50. This oil can be purchased at any auto parts store.
You add tranny fluid right into where the dipstick is
Easy answer to this. Don't put them on stupid cause if you are having this kind of problem they are to big.
4 or 6 cyc, place container under oil pan under the engine, remove the drain plug on bottom of oil pan. on 4 cyc oil filter on top right(passenger side). put new filter, reinstall plug, fill with oil to line on dipstick.
The rear license plate bulbs on a 1996 Olds Cutlass Supreme are replaced by removing the retaining screws, pulling the light assembly out, and disconnecting the wiring harness. The bulb can then be twisted to remove it and a new bulb put in place.
Possible loose convertor bolts.
take off the belt and there is one bolt take it off and put a new one one.
Synthetic motor oil.
hydraullic oil
The kind that you put in it
what kind of hyderlic oil i have to put in jack
Not knowing what engine you have in your Olds, most engines will have the "Mapping" of the belt located somewhere under the hood. On my two Olds, they are located on the valve cover. When you purchase a new belt for your car the cardboard holder for the belt will display several diagrams based upon the engine that the belt will fit..... you out.
actually it's 4.5 qts. but if you just put in 5 qts. with a filter change you will be fine.