0
What is the torque sequence on edelbrock performer aluminum head small block Chevy?
Wiki User
∙ 16y ago
You can get the sequence out of any repair manual such as Motor's, Chiltons, or Haynes. The idea is to start in the center and go in a clockwise pattern working your way out to the ends. Usually three stages is adequate, such as 30 ft/lbs, 45 ft/lbs, then final torque on the third pass.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
What is the torque spec on an Edelbrock aluminum intake manifold for a 78' ford 400m?
Here is the installation instructions for the Edelbrock Performer aluminum intake manifold for a Ford 351M/400...hope it helps out. http://www.edelbrock.com/automotive_new/misc/tech_center/install/2000/2171.pdf
What is the torque specs on an edelbrock aluminum intake manifold for a 69' Chevelle 396?
the edelbrock website should have that info.
What is the torque specs on an edelbrock aluminum intake manifold for a 67' chevy 396?
25 ft./lbs.
What is the torque specs on an Edelbrock aluminum intake manifold for a Pontiac 428?
Iron Intake to Iron Heads - 40ft lbs Aluminum Intake - 25ft lbs
What is the head bolt torque and sequence for 5.0 mustang?
Check Edelbrock or Trick Flow websites maybe call Summit racing 1-800-230-3030
Edelbrock Aluminum Intake Manifold Torque Specs Ford FE?
The Edelbrok dealer Chris said it was 25 lbs. but I just can't believe that so I'am looking around the internet and so far that what it says. I'am thinking it would suck the gasket in with so little torque.
What is the torque on bolts for a edelbrock intake manifold on a 1970 impala 350?
25 ft./lbs.
What is the torque sequence of a 93 Geo Storm?
Torque sequence of what. Heads, wheels, etc.
What is the torque sequence for a Lexus ls400?
torque sequence on what part? more info needed
What is the torque for an edelbrock carburetor on edelbrock intake?
DEPENDS ON WHAT TYPE OF INTAKE AND CARB. YOU'RE BEST BET IS TO GO TO EDLEBROCK.COM, ENTER THE CARBS MODEL NUMBER, AND GET A SPEC SHEET THAT THEY PROVIDE.
Cylinder head torque sequence for a 1991 pathfinder?
what is the head torque sequence for a 1991 pathfinder
What is the torque sequence for rocker arm bolts on a 1991 ford 1.9 engine?
There is no torque sequence just torque rocker arm studs to the proper torque
