0
Consult your shop manual, there is a specific order that the head bolts must be torqued.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
What is the torque for Nissan altima 2.5 cylinder head?
75 degrees
Rover 75 cylinder head bolt torque settings?
THis ain't no question
Torque for the head bolts of a 1975 small block 350?
75-90 ft lbs.
What are the cylinder head torque specs on 75 Chevy small block?
If it is a V8 it is 65FT.- LBS.
What is the Head bolt torque 3.5-v6 Kia Sorento?
75-82 ft lbs
What is torque specs for head bolts on 1986 Chevy 305?
75 lbs--rods 45 lbs
1986 Evinrude 9.9 motor weight?
The dry weight for a 1986 Evinrude 9.9hp outboard is 75 to 88lbs. depending on the model.
How do you repair white smoke emiting lawn mower?
Hi, The most likely cause is a defective head gasket. They normally fail where the push rods pass through from the cylinder to the head. A new gasket is around 20 dollars and is a relatively straight forward job. I normally charge around 75 dollars in my shop to replace a single head gasket, about one hour labor plus the gasket. If you do not feel confident doing the repair, bring it to a reputable shop. It will be done correctly. Then again, it would be a good learning experience. It is critical to have a torque wrench for a newbie doing the job. Torque the head bolts to 25 lb. ft. by progressively tightening little by little. always tighten bolts opposite of each other similar to putting a wheel in a car. Get them all up to about 20 lbs then finalize to 25. run the engine for an hour and recheck. DO NOT use lubricant or never seize on the head bolts. the torque figures are with dry bolts.
What is the gas mix for 50 horse power evinrude?
i got a 75 hp evinrude with a 6.6 gallon fuel tank it use 16 onces of oil
What are the torque specs and pattern on the head bolts of a 1991 Toyota pickup with the 3.0?
The torque specs and pattern on the head bolts of a 1991 Toyota pickup with a 3.0 engine are 5, 4, 6, 3, 2, 7, 1, and 8. This sequence is started from the center of the head and requires 75 foot pounds of torque on each bolt.
What is the head bolt torque on 1993 Eclipse 2 liter dohc?
51-54 ft. lbs. (70-75 Nm)
What is the spark plug gap for a 1975 75 HP Evenrude?
The correct plug gap for the 1975 model, 75 hp Evinrude, is .032 in.
