29mm
The socket size for the front axle nut on a 2004 Kia Rio is typically 32mm. It is recommended to verify this size with the specific vehicle to ensure a proper fit.
36mm
The front axle nut on the 4+4 should be 35mm. You can use a 1 3/8" deep socket but it will fit tight. On my 2000 Chevy s-10 the Nut was 36MM. The socket I bought at advanced auto says right on the package for GM axle nuts.
32mm for the axle nuts.
I'm assuming you're talking about an BMX here... Undo axle nuts, put pegs on. With an extender and a socket wrench, get the axle nuts back on and crank down.
It is a special 2 9/16 inch socket just for axle nuts.
once you remove the retaining tabs off of the washer that are covering the nuts, it takes a 34MM DEEP SOCKET
19 mm
185 to 260 ft lbs this is the front center nut that holds axle and front wheel bearing together not wheel lug nuts
Spindle nuts very from 30mm to 34mm
Jack the car up, loosen the bolts and remove the wheel. The next thing is to loosen the nuts joining the axle to the stath then remove the axle.
step one is the check lug nuts ----------- step 2 is the axle busted grease around axle
The 2004 Chevy Blazer front grill emblem is held in place with two retaining nuts. You can access the retaining nuts from behind the emblem. Remove the retaining nuts and the emblem will come off.