0
What is the reserved loopback IP address that can be used to test the configuration of the local IP device?
Wiki User
∙ 9y ago
resever ip of loop back is 127.0.0.1
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
What are the difference between local loop back testing and remote loop back testing?
The only difference is the relative location of the device that is in loopback mode. Local loopback testing is when your device is set to send back everything it receives to the sender, aka loopback mode. Remote loopback testing is when your device orders a foreign device to enter loopback mode.
What is the lo device displayed in the ifconfig command?
it's the loopback address. The IP address listed under it can be pinged to test to see if your NIC is working
What device is used to perform a loopback test on a nic?
base1000
Where does the wizard obtain the loop-back address?
Your loop-back address or localhost is always 127.0.0.1. When a packet is sent to this address, the packet is routed internally to the network loopback device. The packet is then received back by your computer as if it came from an outside source.
What is an automated means of assigning an IP address to every device on a network?
DHCP (Dynamic Host Configuration Protocol) is an automated means of assigning a unique IP address to every device on a network.
What is an automated means of assigning a unique IP address to every device on a network?
DHCP (Dynamic Host Configuration Protocol) is an automated means of assigning a unique IP address to every device on a network.
What are the two ways to use the ping utility to test a local computers NIC?
go to command prompt and type in either Ping Loopback, or Ping 127.0.0.1 or Ping another device's IP Address
What are the special IP addresses. Give the special IP address for loopback?
There are several IP addresses that are special in one way or another. These addresses are for special purposes or are to be put to special use.Addresses significant to every IP subnet Network AddressBroadcast AddressAddresses significant to individual hosts Loopback AddressSpecial Addresses of Global Significance Private AddressesReserved AddressesLOOPBACK ADDRESS (127.0.0.1)The 127.0.0.0 class 'A' subnet is used for only a single address: the loopback address 127.0.0.1. This address is used to test the local network interface device's functionality. All network interface devices should respond to this address. If you ping 127.0.0.1, you can be assured that the network hardware is functioning and that the network software is also functioning.
What are cisco device configuration commands?
cisco configuration command guide
What configuration of a router would be restored to the device after the reload?
The System Configuration Dialog of a router would be restored to the device after the reload.
How do you change the IP address on HP 2420 printer?
Menu > Configure Device > I/O > Embedded JetDirect Menu > TCP/IP > Manual Settings > IP Address
What devices are generally configured in the PC Setup program?
System configuration, Boot order, Boot (start-up) configuration and docking-device configuration settings, Basic device configuration settings, Battery charge status and System security and hard-drive password settings
