Symphonic codes for dish network

Answer 1

Remote: Basic Remote (Television Only)

1. Turn the Television On.
2. Press and hold the TV Power button for three seconds until the LED flashes.
3. Press and release the TV Power button.
4. Press and release the Up or Down Arrow on the remote until the television turns off.
5. After the television turns off, press and release the OK button.
6. Test functionality with the TV.
7. Return to Step 2 if the remote is not able to turn the TV On/Off, change the volume and mute the television.

i have provided a link where you can program your remote to your TV. Select your receiver model at the bottom of the page, which will open a PDF file with the codes for different TV manufacturers. Find your TV brand for the codes.

Here are more codes for your TV: 527, 541, 569, 587, 646, 679, 682

http://www.dishnetwork.com/SupportSection/setup-remote

Ray Calo

DISH Network

The codes from the manual for Symphonic are as follows:

632, 657, 662, 677, 692 & 694

Answer 2

Here are the top 3 codes for your Symphonic TV: 632, 733, or 846. I have also provided instructions on how to program the remote to your TV.

1. Address Remote to TV/Other Devices
2. While at the device location (TV, etc), point the remote at the device. Press and hold the red TV button on the remote - All four mode buttons should light up
3. Enter the three-digit remote control code - The TV button you selected should light up
4. Press the Pound (#) button - The mode button you are programming should flash three times
5. Press the large, red POWER button - The device should turn off

Thanks.