depending on the thickness of steel you have to change your amperage.... i like to work with 120 or higher with 1"1/2 angle iron The thump rule for any welding rod current selection is as follows: Current = Core wire Dia of the Electrode X 40 Example (4mm X 40 = 160 Amps ) Current shall be lowered & increased based on the welding position & Job thickness etc and also depends on the welder skill & job nature +/- 10 to 20% on the above.
6013 is normal arc electrode which is used for light jobs like sheet welding or tank making but when it comes to heavy construction jobs where strength required is more 7018(Low Hydrogen) Arc Electrode is used like boilers, heavy structures etc. Working with 6013 is far easier than 7018, which requires welder's skills. Neatness in finishing is also more with 6013 than 7018. any further info. on construction : nangalsuri@rediffmail.com Surinder Singh
6010 is intended for DC welding. It has no additives in the covering to keep the arc going each time the AC voltage reverses, so it is very hard to keep the arc struck. The result is usually poor quality welds. The solution is to switch to a rod designed for AC, such as 6013.
6010 is intended for DC welding. It has no additives in the covering to keep the arc going each time the AC voltage reverses, so it is very hard to keep the arc struck. The result is usually poor quality welds. The solution is to switch to a rod designed for AC, such as 6013.
The 'arc' in arc welding is not an acronym but in turn is a reference to the electric arc that is being generated during the welding process.
If you are asking for the correct nomenclature it is Shielded Metal Arc Welding.
Almost all welding today is done with electricity (Arc Welding) even on cast iron. SMAW, GTAW, GMAW etc. --AW means Arc Welding.
Yes, arc welding does create ozone. It is because the temperatures created during arc welding convert the nearby oxygen to ozone.
smaw welding is sheilded metal arc welding
Gas Tungsten Arc Welding Gas Metal Arc Welding Flux Cored Arc Welding
If you are asking for the correct nomenclature it is Shielded Metal Arc Welding.
Arc welding uses an electrical current to create enough heat to melt metal. Any type of welding that uses an electric arc is technically arc welding. However, most people use the term 'arc welding' to mean shielded metal arc welding (SMAW), or 'stick welding'. SMAW, MIG, and flux core wire welding use the filler metal as both electrode and filler; TIG welding uses an electric arc to heat the base metal and a separate filler rod to add metal to the weld.
ARC welding uses large amounts of electricity to melt the metal, not a hot flame. So no, LPG cannot be used for ARC welding.