Identifies the interface as connected to the outside
clear ip nat translation outside
IP NAT Command is used to Exclude the IP from Routing Table or Tells the Router to fix the IP Static or exclude the IP from Route. used for Network Address Translation
When you want to configure a simple IP parameter for a network, use the command IPConfig. This is used for TCP/IP setups for business and residential networks by computer technicians.
NAT stands for Network Address Translation. NAT's primary role is to configure IP addresses. When NAT is configured to a firewall, it reconfigures the addresses of certain IP packets as they pass through the firewall or through a router.
NAT stands for Network Address Translation. NAT's primary role is to configure IP addresses. When NAT is configured to a firewall, it reconfigures the addresses of certain IP packets as they pass through the firewall or through a router.
Yes. That's the whole idea of private IP addresses. With NAT, the outside world never "sees" your private IP addresses.Yes. That's the whole idea of private IP addresses. With NAT, the outside world never "sees" your private IP addresses.Yes. That's the whole idea of private IP addresses. With NAT, the outside world never "sees" your private IP addresses.Yes. That's the whole idea of private IP addresses. With NAT, the outside world never "sees" your private IP addresses.
In Linux, you can configure a network card (it;s IP address, and if it is turned on or off) with the 'ifconfig' command.
With the Windows Command Prompt, you can enter the command "ipconfig" and then configure everything you just stated in your question.
R3#configure terminalR3(config)#access-list 104 permit ip 10.0.0.128 0.0.0.127 anyR3(config)#ip nat inside source list 104 interface Serial0/0/0 overloadR3(config)#interface fastEthernet0/1R3(config-if)#ip access-group 104 inR3(config-if)#ip nat insideR3(config-if)#exitR3(config)#interface Serial0/0/0R3(config-if)#ip nat outsideR3(config-if)#exitR3(config)#interface Serial0/0/1R3(config-if)#ip nat outsideR3(config-if)#endWriting by vanhuuvt32bonphuonglanha@gmail.com
clear ip nat translation
debug ip nat
That depends very much on what you want to configure with it. Many aspects, such as MAC address and IP address, can be configured with the ifconfig command.