What does it mean when there is a clicking noise in the right front wheel area on a 2008 Chrysler sebring?
You need to replace the front axle Every 80,000 to 120,000 They wear out, normal maintance
2 people found this useful
Answer . \nYou did not say what kind of vehicle it is. If it is a front wheel drive, it has drive axles and if the drive axle is going out, it will click especially when yo…u turn the wheels.
What would cause a 1999 Chrysler Sebring LXI front driver side to make a loud growling noise not a popping noise when turning left around a curve but be completely quiet when turning to the right?
Answer . Could be a wheel bearing
Answer . It is likely the CV (Constant Velocity) joint. If left unattended, the joint will eventually break completely and the car won't go anywhere.
Answer . most likely it is a cv joint going bad, but it can also be a strut tower, or a tie rod.... Answer . front right strut
You need a new door check. You can replace yourself if you are mechanically inclined.. You need a new door check. You can replace yourself if you are mechanically inclined.
What is the clicking noise your car makes when you back up and turn the wheel in your Chrysler Pacifica?
Front main axle or CV joint.... that's assuming this car is front wheel drive
Both. If both tires have equal traction the power is split betweenboth.
The drive shaft may need to be tightened
It is inside the driver side fender.
Both of the front wheels on my 99 Sebring have fallen off in the last year. Caused by failed lower ball joints.
It is rear wheel drive.
If its a clicking sound check your c/v joint. It gets real loud when going around a corner
No, front wheel drive only.
In Car Sounds
Why does the left front end of your 2004 Chrysler sebring make a humming noise when going straight or turning left over 25 mph but stops when turning right?
A failing wheel bearing is a likely cause.
All Sebring convertibles are front wheel drive. They have been produced since model year 1996 and are now in the third generation.