answersLogoWhite

0


Best Answer

More information: I went in because I was having electrical issues which they could not fix but insisted my front brakes are at 20% and rear brakes are at 0%.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What does it mean when my dealership tells me my 2008 Jeep Wrangler needs new rear brake rotors and pads at 30000 miles even though I hear no screeching or grinding?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Does a 2006 Jeep Wrangler have rotors or drums on the front axle?

RotorsRotors


What sound does it make when rotors are bad?

Grinding


When brakes start grinding is it just pads or rotors too?

The grinding noise is from the the pads being gone and rotors being grinded away. Unless it was just some rust on the rotors from sitting for days.


Signs of bad brake rotors?

A pulsation when braking, and a loud screeching noise(pads also gone).


Does 97 wrangler Sahara have floating front rotors?

Yes.


Grinding clicking sound when you drive?

Check your brakes(pads and rotors)


Why are your brakes grinding?

Pads are worn down Rotors are rusty and scoured Dirt and grit have been trapped between pads and rotors


What would cause a grinding noise near the tires on a QX4?

bad rotors


How do I keep my steering wheel from shaking when my brakes are applied?

Have the front rotors turned on a lathe at a dealership. check brakes and rotors


What causes grinding and vibration when you accelerate?

Typically its wheel barrings but can also be bad rotors.


Could rusty rotors make a grinding noise?

Normally a rusty rotor would not make a grinding noise. A grinding noise from the brakes usually indicated that the pads or shoes are worn down.


Possible problems on a 2000 Focus with grinding noise before and after new brakes?

I had a similar experience with my Windstar - lots of pad material left, but still grinding after new pads & shoes. Turns out the rotors were bad. :( Btw, I just replaced the rotors without finding out if a simple turning would have eliminated the grinding.