0
What does each of the wires mean that come up to the back of the radio?
Simssedition
12
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
How do you remove radio in 1995 Toyota Corolla?
To remove the radio in a 1995 Toyota Corolla, first pry the radio frame from the dashboard using a flat tool like a screwdriver. Then, press in on the pins at each side of the radio and slide it out of the dashboard. Remove the wires from the back of the radio.
Why does your radio lose all power when you turn on your headlights on your 98 wrangler?
A radio losing power when you turn on your headlights indicates the wiring is crossed. The wiring harness will have dozens of wires in it. When 2 wires are bared and touching each other, they can short each other out.
How do I remove a 1990 Lexus es250 radio?
To remove the radio from the 1990 Lexus ES250, first pry the face plate from the dashboard. Then remove the clips that hold each side of the radio. Then, remove the wires to release the radio.
How do you remove a radio for a 1994 Mercury Grand Marquis?
Go down to the parts store or Wal-Mart and buy a radio puller. It is two horse shoe shaped wires with little notches on the ends. You put the pullers into the holes in the face of the radio. There should be two on the right and two on the left, above and below each other. Push them in until they lock in and then just pull out. You may have to spread the pullers toward the outside to get a good bite on the radio. Then, you just pull out and the radio slides out. Then unplug the wires from the back.
How do you get the radio out of a 1990 Geo Metro?
I have done this quite a few times so I'll give you step by step instructions. #1. Remove the trim or bezel from around the radio, this just snaps in and snaps out so no problems there #2. You should see 2 to 4 screws on each side of the radio, unscrew these and keep them where you'll remember #3. remove the radio and unplug the 2 wires on the back, then install the new radio and put back in the screws and bezel. Its very easy once you get ahold of it. Good luck.
How do you fit the speaker cables to the head unit on a Clio?
Assuming there is 8 wires in existing Renault wiring iso speaker plug at back of radio, the two outer wires at each end of plug are for left rear and right rear speakers, tap into these wires i.e. strip the insulation back a couple of inches from the plug and join new speaker wires onto the stripped wires. If only 4 wires in existing Renault wiring iso speaker plug then buy iso speaker plug from auto factor and join existing Renault wiring on speaker plug onto new cable and join new speaker cables (the ones you are fitting) onto the outside wires at each end of the new iso plug.
Where else would you check to get the dashboard lights to work on the 1995 Dodge Neon?
If the problem occured because you removed the radio,I found I had to ground the wire going to the radio light to complete the circuit,then all my dash lights came on.If you have a small bulb connected with 2 wires,with one going to ground touch the other wire to each of the wires in the radio connecting plug one at a time and see if your dash lights come on. you must have car`s main light switch turned on first.
How do you remove radio from 2003 4 runner?
look on top of the radio there is a tray. grab the top of the tray and pull out there are clips that hold it together then just let it hang from the wires you will see the radio on brackets then just remove the 4 bolts from the bracket and pull the radio out dont forget to remove the conncetions on the back. once you remove the radio there are 4 screws on each side of the radio that is holding the radio to the bracket. remove those to remove radio from bracket. dont lose those screws your going to need them to install on new radio. any more questions e-mail emezahth@gmail.com
Is is it important to wait for the chest to come back to its original position after each compression?
It is not important to wait for the chest to come back to its original position after each compression
Is it important to wait for chest to come back to its original position after each compression?
It is not important to wait for the chest to come back to its original position after each compression
How do you remove the factory radio from a 1989 Ford Tempo?
Remove the neg battery cable tehn the aC ducts under the dash. Then take the wires and bolts holding the radio from under the dash. Then remove the knobs and the nuts under them. Work the radio out from under the dash. First remove the bezel from the dash, (around the radio). Use 4 heavy pieces of wire and insert one into each of the holes in the corners of faceplate of the radio. Push them in approx. 2 inches then pull the radio out the front and disconnect the wires and antenna.
What is an axial lead resistor?
It's a resistor where the leads (wires) are axial (they come in at the center of each end of the resistor).
