This is a common problem with Montana vans. Its usually bad wire which runs under the front passenger side carpet.
Check the other lock switch and see if it works. If it does you have a bad switch and it needs to be replaced. If neither one works you may have to take it to a dealer
Don't take it to the dealer! This is EASY! I just finished fixing mine. The remote worked fine, the key worked fine, but the switches did not, and I wasn't about to fork out dough for a switch I didn't need. Pull off the sill plate on the passenger side, and the kick panel. Pull up the carpet toward the middle of the van, and have someone hold it there. You will have to unravel a bunch of electrical tape from the harness.There are two wires (one white, one blue) that have connectors that go from one wire each to two wires each. Cut these connectors off and replace them with a new good piece of wire, about 5 inches long. Solder if possible, tape them up or better still use shrink wrap if possible. Tape up the harness, and put the carpet, kick panel and sill plate back in. Total time 15 minutes.
with the motor running and radio off press buttons 1 and 4 on the radio this should unlock the radio
hold the unlock button in for 3-5 seconds
clean contacts on door and van body, low front of slider door
What is the unlock code for a pontiac g6
See if your passenger floorboard is wet. If so, look for corroded wires. If you fix the wires, it should correct your problem. I have a Chevy Venture that had the same problem and this worked.
i read another anser similar to yours it said to press the 4 and 6 buttons together and this will give you a 6 didget code that you can give to your local dealer and he or she will give you the code to unlock . i hope this helps you. graverobber1971. Most dealers will Charge you $60 to do this .After you get the code go on Ebay and search for gm radio codes . it cost me $1.50 for the codeon my Montana.
I had a 1999 Montana in which the door locks would cycle from lock to unlock, also when I turned on (if I remember the right turn signal). Took to dealer and they diagnosed the BCM (body control module) bad. I did NOT have them replace it due to cost. The problem was a bad ground connection for the BCM.
Go to the gm service center nearest you with title/proof you own this vehicle, and probably pay to have a gm technician utilize a gm scan tool to re-set the security system between the radio and the pcm.
flip the lock switch to unlock....
i dont know . you gotta figure out how to do it yourself.
You unlock nothing.
Unlock it from inside the car with the door lock.