When Installing The Toilet Back, Get A Straw Cut It In Half. Put One Over Each Of The Bolts Then Guide The Straws Into The Holes For The Bolts. This Works Great And Saves Time And Trouble Getting It Back On. Where the toilet meets the floor, there is a wax (or similar material) ring which creates a seal. If this is leaking, you will want to replace it. Turn the water off. Flush twice to empty the tank. Disconnect the water line from the toilet. (Have some towels handy!) Unbolt the toilet at the base. Carefully remove the toilet from the floor. Remove the old wax seal and replace it with new, available from any hardware store. Replace the toilet, water line, bolts etc. Turn the water on and give her a test flush. You should be all set!
Water and waste
Incorrect pipe size installations
Depends on if it needed to be flushed or not.
yes,toilet water is clean it is actually the same water you drink........if its flushed No, it have AIDS in it.
NO.
NO way
Sound like you have a clogged toilet and or a clog in your main drain under your toilet. Shut off water supply to toilet remove water from toilet tank. Puchase a wax ring for your toilet prior to disconnecting toilet from supply line and floor bolt on the right and left of your toilet. Remove toilet from floor if water is standing in pipe under where toilet was this is where your problem lies. If no water or clog present, turn toilet on side and lokk in hole at the bottomof toilet. Clear was is stuck in toilet clean off old wax ring install new one and put toilet back together.
maybe bcuz to save water..
Goes straight to sewer
things that get flushed down the toilet sink bath all of that.
1.6 - 3.5 gpf
Because the flapper is stuck.